DF30CJ-xxx HRS, DF30CJ-xxx Datasheet - Page 11

• Manufacturer Part Number: DF30CJ-xxx
• Description: 0.4mm Pitch / 0.9mm Height / Board-to-board Connectors
• Manufacturer: HRS

BHandling Precautions when un-mating the connectors
Fully mated
Lift even one side, keeping both boards parallel to each other.
When handling circumstances prevent the connector from being
kept level during un-mating, one end may be lifted separate as
shown on Fig. A.
However, to utilize this procedure the connector must be mounted
on a sufficiently rigid circuit board.
Any deflection of the board during this operation may result in
damage to the connector or solder joints.
Do not attempt the start of the un-mating of the connectors from one
side (Fig. B).
Fig. A
Fig. B
When removal is from the width orientation as illustrated in the
diagram to the left, damage could be caused to the connector. Do
not perform removal from the width orientation.
11