CML0306 Cyntec Co., Ltd., CML0306 Datasheet - Page 14

• Manufacturer Part Number: CML0306
• Description: 0201 Series Thin Film Chip Inductor Lead / Halogen Free
• Manufacturer: Cyntec Co., Ltd.

CYNTEC CO., LTD.
乾坤科技股份有限公司
乾坤科技股份有限公司
7. Precautions
乾坤科技股份有限公司
乾坤科技股份有限公司
7-1 Storage
7-2 Term for use
7-3 Chip mounting
(1) The product shall be stored in a room where temperature and humidity must be controlled.
(2) The product shall be stored as direct sunshine doesn't hit on it.
(3) The product shall be stored with on moisture, dust, a material that will make solderability
(4) The product shall be stored as tape packaging condition.
(1) The term for use is within one year from the shipping day of the product.
(2) If the product has been left unused for more than one year after delivered, check solderability
(1) When chip are mounted on PC board, protective coat of the product must not be scratched. If
(2) In case that product will be soldered by soldering iron, heating shall be done on the land, and
(3) In case that resin coating or resin seal will be made for a PC board after chip mounting, do
(4) For resinous use, it is necessary to set up enough the curing conditions. As it gets improper
(5) According to shape, material, and pressure of clamping in chip mounting machine, there is
(6) The glue to fix the product on the PC board around chip mounting, it is needed high
(temperature: 5-35℃, humidity : 45-85% RH).
However, humidity keeps it low, as it is possible.
inferior, and a harmful gas (hydrogen chloride, sulfurous acid gas, and hydrogen sulfide).
before use.
it will be scratched, it will make characteristic inferior.
soldering iron must not hit on the product itself.
washing and drying it enough before coating or sealing. If ion bear or moisture will be sealed
in resin coating, it will make characteristic inferior.
for the condition, changes of a resistance value are large and are a case.
the case that crack will be appeared on the product.
Control a shock energy for clamping the product under 7 x 10
With a shock energy around clamping that says here, it is suited to a potential energy, in case
that iron block of 25 g is dropped naturally to the product placed on iron plate for the height
of 2.8mm.
insulation resistance and great performance or moisture. And it is needed that these
characteristics are not inferno in using temperature range and a hot spot temperature to be
acting.
-4
DOCUMENT : CYNP-8Z-031
REVISION
PAGE
J .
: 14 OF 15
: A5