CML0510-1N0 Cyntec Co., Ltd., CML0510-1N0 Datasheet - Page 10

• Manufacturer Part Number: CML0510-1N0
• Description: 0402 Series Thin Film Chip Inductor Lead / Halogen Free
• Manufacturer: Cyntec Co., Ltd.

CYNTEC CO., LTD.
乾坤科技股份有限公司
乾坤科技股份有限公司
乾坤科技股份有限公司
乾坤科技股份有限公司
7. Caution on using chip inductor
7-1 When storing the product
7-2 When mounting the product
(1) Store the product in an environmentally well-controlled room (temperature: 5-35℃,
(2) Store the product in a place free of substances which deteriorate Solderability (moisture, dust)
(3) Store the product away from direct sunlight.
(1) To solder with a soldering iron, heat the land with the soldering iron, avoiding contact with
(2) Unsuitable shape and material of the chuck claw, or excessive shock caused by the chucking
(3) Do not scratch the protective coat or housing surface of the product before, during or after
(4) When coating or sealing the mounted board with resin, completely wash and dry the board
humidity : 45-85% RH). Humidity should be kept as low as possible.
and which is free of poisonous gases (hydrogen chloride, hydrogen sulfide).
If the place does not meet the above conditions, or if the product has been left unused for
more than one year after delivered, check Solderability before use.
the iron edge of the product. If the product temperature exceeds 300°C, the protective film
may have damage and the characteristics of the products may be changed.
pressure of the chip-mounting machine may crack the product.
The striking energy at chucking should be 7 x 10
The striking energy at chucking, in this context, is equivalent to the kinetic energy generated
when a 25g-iron block falls from a height of 2.8mm.
mounting the product. Scratches on the product may deteriorate the durability.
beforehand. Sealing the product, which is moistened or contaminated with ions, may
deteriorate the durability. Before using the resin, fully examine its quality and reliability. If
improper resin is used, the electric characteristics of the product may change.
When gluing the product to the board, use adhesive, which has high insulating resistance and
excellent durability. Also, the resin must have characteristics, which do not deteriorate within
the operation temperature range or the temperature range of products in use.
-4
J or less.
DOCUMENT : LLF00000NH
REVISION
PAGE
: 10 OF 11
: A0