TDA8510 Philips Semiconductors, TDA8510 Datasheet - Page 5

• Manufacturer Part Number: TDA8510
• Description: 26 W BTL and 2 x 13 W SE power amplifiers
• Manufacturer: Philips Semiconductors

Philips Semiconductors
FUNCTIONAL DESCRIPTION
The TDA8510J contains four identical amplifiers and can
be used for two Single-Ended (SE) channels (fixed gain
20 dB) and one Bridge-Tied Load (BTL) channel (fixed
gain 26 dB). Special features of the device are:
Mode select switch (pin 14)
To avoid switch-on plops, it is advised to keep the amplifier
in the mute mode during 100 ms (charging of the input
capacitors at pins 1, 3, 15 and 17). This can be achieved
by:
Diagnostic output (pin 16)
D
At the onset of clipping of one or more output stages, the
dynamic distortion detector becomes active and pin 16
goes LOW. This information can be used to drive a sound
processor or DC volume control to attenuate the input
signal and thus limit the distortion. The output level of
pin 16 is independent of the number of channels that are
clipping (see Figs 3 and 4).
S
When a short-circuit occurs at one or more outputs to
ground or to the supply voltage, the output stages are
switched off until the short-circuit is removed and the
device is switched on again, with a delay of approximately
20 ms, after removal of the short-circuit. During this
short-circuit condition, pin 16 is continuously LOW.
When a short-circuit across the load of one or more
channels occurs the output stages are switched off for
approximately 20 ms. After that time it is checked during
approximately 50 s to see whether the short-circuit is still
present. Due to this duty cycle of 50 s/20 ms the average
current consumption during this short-circuit condition is
very low (approximately 40 mA).
1999 Dec 14
HORT
YNAMIC
Low standby current (<100 A)
Low switching current (low cost supply switch)
Mute facility.
Microcontroller control
External timing circuit (see Fig.8).
26 W BTL and 2
amplifiers
-
CIRCUIT PROTECTION
D
ISTORTION
D
ETECTOR
13 W SE power
(DDD)
5
During this short-circuit condition, pin 16 is LOW for 20 ms
and HIGH for 50 s (see Fig.5).
The power dissipation in any short-circuit condition is very
low.
handbook, halfpage
handbook, halfpage
Fig.3 Distortion detector waveform; BTL channel.
Fig.4 Distortion detector waveform; SE channels.
V O
V
V 16
V O
16
V P
V P
0
0
0
0
Preliminary specification
TDA8510J
MGA705
MGA706
t
t