madr-009190-000100 M/A-COM Technology Solutions, Inc., madr-009190-000100 Datasheet - Page 8

• Manufacturer Part Number: madr-009190-000100
• Description: Quad Driver Gaas Diode Switches Attenuators
• Manufacturer: M/A-COM Technology Solutions, Inc.

8
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.
Commitment to produce in volume is not guaranteed.
Quad Driver for GaAs FET or PIN Diode
Switches and Attenuators
Lead-Free, SOIC-16
MADR-009190-000100
Description of Circuit
The MADR-009190-000100 provides four pairs of complementary outputs that are each capable of driving a
maximum of ± 35 mA into a load. In addition, with proper capacitor selection (C3 & C4) used in parallel with
the current setting resistor (R1 & R2), additional spiking current can be achieved.
To achieve the Non-Inverting and Inverting complementary voltages, each output is switched between two
internal FETs. The FETs are connected to V
and V
tive than –10.5 volts; V
equal to V
by the logic input. The most common configuration is to drive V
at +5.0 volts.
†
Reference Application Note M538 for lead-free solder reflow
recommendations.
EE
are adjustable for various configurations and have the following limitations: V
CC
. Increasing V
OPT
†
OPT
can be no more positive than +7.0 volts AND V
beyond V
CC
will prevent the device from switching states when commanded to
OPT
for the positive output and V
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
changes to the product(s) or information contained herein without notice.
• North America Tel: [phone] • Europe Tel: [phone]
• India Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
EE
at –5.0 volts with V
OPT
EE
for the negative output. V
must always be less than or
CC
EE
can be no more nega-
and V
• China Tel: [phone]
OPT
tied together
Rev. V1
OPT