sx8633 Semtech Corporation, sx8633 Datasheet - Page 15

• Manufacturer Part Number: sx8633
• Description: Microsoft Word - Sx8633_v77_final_std.doc
• Manufacturer: Semtech Corporation

SX8633
Low Power, Capacitive Button Touch Controller (12 sensors)
with Enhanced LED Drivers and Proximity Sensing
ADVANCED COMMUNICATIONS & SENSING
DATASHEET
3.7 Analog Sensing Interface
The Analog Sensing Interface (ASI) converts the charge on the sensors into ticks which will be further digitally
processed. The basic principle of the ASI will be explained in this section.
The ASI consists of a multiplexer selecting the sensor, analog switches, a reference voltage, an ADC sigma delta
converter, an offset compensation DAC and an external integration capacitor (see Figure 11).
Analog Sensor Interface
Figure 11
To get the ticks representing the charge on a specific sensor the ASI will execute several steps.
The charge on a sensor cap (e.g. CAP0) will be accumulated multiple times on the external integration capacitor,
Cint.
This results in an increasing voltage on Cint proportional to the capacitance on CAP0.
At this stage the offset compensation DAC is enabled. The compensation DAC generates a voltage proportional
to an estimation of the external capacitance. The estimation is obtained by the offset compensation procedure
executed e.g. at power-up.
The difference between the DAC output and the charge on Cint is the desired signal. In the ideal case the
difference of charge will be converted to zero ticks if no finger is present and the number of ticks becomes high in
case a finger is present.
The difference of charge on Cint and the DAC output will be transferred to the ADC (Sigma Delta Integrator).
After the charge transfer to the ADC the steps above will be repeated.
The larger the number the cycles are repeated the larger the signal out of the ADC with improved SNR. The
sensitivity is therefore directly related to the number of cycles.
The SX8633 allows setting the sensitivity for each sensor individually in applications which have a variety of
sensors sizes or different overlays or for fine-tuning performances. The optimal sensitivity is depending heavily on
the final application. If the sensitivity is too low the ticks will not pass the thresholds and touch/proximity detection
will not be possible. In case the sensitivity is set too large, some power will be wasted and false touch/proximity
information may be output (ie for touch buttons => finger not touching yet, for proximity sensors => finger/hand not
close enough).
Once the ASI has finished the first sensor, the ticks are stored and the ASI will start measuring the next sensor
until all (enabled) sensors pins have been treated.
In case some sensors are disabled then these result in lower power consumption simply because the ASI is active
for a shorter period and the following processing period will be shorter.
Revision 7_7, September 10
© 2010 Semtech Corp.
www.semtech.com
15