lan9218 Standard Microsystems Corp., lan9218 Datasheet - Page 90

• Manufacturer Part Number: lan9218
• Description: Lan9218 High-performance Single-chip 10/100 Ethernet Controller With Hp Auto-mdix Support
• Manufacturer: Standard Microsystems Corp.

Revision 2.3 (08-06-08)
5.3.23
BITS
31
EPC Busy: When a 1 is written into this bit, the operation specified in the
EPC command field is performed at the specified EEPROM address. This
bit will remain set until the operation is complete. In the case of a read this
means that the host can read valid data from the E2P data register. The
E2P_CMD and E2P_DATA registers should not be modified until this bit is
cleared. In the case where a write is attempted and an EEPROM is not
present, the EPC Busy remains busy until the EPC Time-out occurs. At that
time the busy bit is cleared.
Note:
E2P_CMD – EEPROM Command Register
This register is used to control the read and write operations with the Serial EEPROM.
Offset:
EPC busy will be high immediately following power-up or reset.
After the EEPROM controller has finished reading (or attempting to
read) the MAC address from the EEPROM the EPC Busy bit is
cleared.
DESCRIPTION
B0h
DATASHEET
90
High-Performance Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX Support
Size:
32 bits
TYPE
SC
DEFAULT
SMSC LAN9218
Datasheet
0