s-8215a Seiko Instruments Inc., s-8215a Datasheet - Page 16

• Manufacturer Part Number: s-8215a
• Description: S-8215a Series Battery Protection Ic
• Manufacturer: Seiko Instruments Inc.

16
BATTERY PROTECTION IC FOR 4-SERIAL / 5-SERIAL CELL PACK (SECONDARY PROTECTION)
S-8215A Series
Precaution
[For SC PROTECTOR, contact]
• Do not connect batteries charged with V
• In some application circuits, even if an overcharged battery is not included, the order of connecting batteries may be
• Before the battery connection, short-circuit the battery side pins R
• The application conditions for the input voltage, output voltage, and load current should not exceed the package power
• Do not apply to this IC an electrostatic discharge that exceeds the performance ratings of the built-in electrostatic
• SII claims no responsibility for any disputes arising out of or in connection with any infringement of patents owned by a
V
restricted to prevent transient output of CO detection pulses when the batteries are connected. Perform thorough
evaluation with the actual application circuit.
Protection IC Connection Examples”.
dissipation.
protection circuit.
third party by products including this IC.
Sony Chemical & Information Device Corporation, Electronic Device Marketing & Sales Dept.
Gate City Osaki East Tower 8F, 1-11-2
Osaki, Shinagawa-ku, Tokyo, 141-0032 Japan
TEL [phone]
Contact Us: http://www.sonycid.jp/en/
CUn
+ V
HCn
or more, the S-8215A series may become overcharge status after all pins are connected.
CUn
Seiko Instruments Inc.
+ V
HCn
or higher. If the connected batteries include a battery charged with
VDD
and R1, shown in the figure in “
Rev.1.1
Battery
_00