t6817-tksy ATMEL Corporation, t6817-tksy Datasheet

no-image

t6817-tksy

Manufacturer Part Number
t6817-tksy
Description
T6817 Dual Triple Dmos Output Driver With Serial Input Control
Manufacturer
ATMEL Corporation
Datasheet
Features
1. Description
The T6817 is a fully protected driver interface designed in 0.8-µm BCDMOS technol-
ogy. It can be used to control up to 6 different loads by a microcontroller in automotive
and industrial applications.
Each of the 3 high-side and 3 low-side drivers is capable of driving currents up to
600 mA. The drivers are freely configurable and can be controlled separately from a
standard serial data interface. Therefore, all kinds of loads such as bulbs, resistors,
capacitors and inductors can be combined. The IC design is especially supportive of
H-bridges applications to drive DC motors.
Protection is guaranteed in terms of short-circuit conditions, overtemperature, under-
and overvoltage. Various diagnosis functions and a very low quiescent current in
standby mode open a wide range of applications. Meeting automotive qualifications in
the area of conducted interferences, EMC protection and 2 kV ESD protection provide
added value and enhanced quality for the exacting requirements of automotive
applications.
Three High-side and Three Low-side Drivers
Outputs Freely Configurable as Switch, Half Bridge or H-bridge
Capable of Switching All Kinds of Loads Such as DC Motors, Bulbs, Resistors,
Capacitors and Inductors
0.6A Continuous Current Per Switch
Low-side: R
High-side: R
Very Low Quiescent Current I
Outputs Short-circuit Protected
Overtemperature Prewarning and Protection
Undervoltage and Overvoltage Protection
Various Diagnosis Functions Such as Shorted Output, Open Load, Overtemperature
and Power Supply Fail
Serial Data Interface
Daisy Chaining Possible
SSO20 Package
DSon
DSon
< 1.5 Versus Total Temperature Range
< 2.0 Versus Total Temperature Range
S
< 20 µA in Standby Mode
Dual Triple
DMOS Output
Driver with
Serial Input
Control
T6817
4670D–BCD–04/07

Related parts for t6817-tksy

t6817-tksy Summary of contents

Page 1

... Daisy Chaining Possible • SSO20 Package 1. Description The T6817 is a fully protected driver interface designed in 0.8-µm BCDMOS technol- ogy. It can be used to control different loads by a microcontroller in automotive and industrial applications. Each of the 3 high-side and 3 low-side drivers is capable of driving currents up to 600 mA ...

Page 2

... CLK Input register CS 3 Output register INH Fault detect LS3 T6817 2 HS2 HS1 12 14 Fault Fault detect detect ...

Page 3

... CS = low, therefore, several ICs can operate on only one data output line only. 19 VCC Logic supply voltage (5V) 20 GND Ground (see pin 1) 4670D–BCD–04/07 GND 1 20 GND VCC CLK 4 17 LS1 INH 5 16 HS1 LS2 HS2 LS3 8 13 GND n. HS3 GND 10 11 GND max T6817 = 2 MHz) 3 ...

Page 4

... SLS1 SHS1 SLS2 SHS2 SLS3 SHS3 Table 3-1. Bit T6817 4 LS2 HS2 LS3 HS3 n.u. n. n.u. n.u. Input Data Protocol Input Register Function Status register reset (high = reset; the bits PSF, SCD and overtemperature ...

Page 5

... High = standby, low = normal operation PSF Power supply fail: over- or undervoltage at pin VS detected Bit high: overtemperature shutdown Bit 10 Bit 9 Bit 8 Bit 7 n.u. n.u. n.u. n.u. Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 (HS3) (LS3) (HS2) (LS2) (HS1 T6817 Bit 1 Bit 0 (LS1) (SRR ...

Page 6

... SRR bit in the input register, the SCD bit is reset and the disabled outputs are enabled. 3.6 Inhibit There are two ways to inhibit the T6817: 1. Set bit SI in the input register to zero 2. Switch pin 5 (INH both cases, all output stages are turned off but the serial interface stays active. The output stages can be activated again by bit and by pin 5 (INH) switched back to 5V ...

Page 7

... HS3 T –40 to +150 j –55 to +150 STG Value 25 thJP 65 thJA Min. Typ. ( 4.5 5 VCC V V –0.3 CLK CLK T –40 j T6817 Unit °C °C Unit K/W K/W Max. Unit ( 5 VCC 2 MHz 150 °C ...

Page 8

... Type means: A =100% tested 100% correlation tested Characterized on samples Design parameter Note: 1. Delay time between rising edge of CS after data transmission and switch on/off output stages to 90% of final level T6817 8 Test Conditions ISO 7637–1 VDE 0879 Part 2 MIL-STM 5.1 – ...

Page 9

... T6817 Unit Type* °C A ° °C A ° µA A µ mV/µ µ ...

Page 10

... Type means: A =100% tested 100% correlation tested Characterized on samples Design parameter Note: 1. Delay time between rising edge of CS after data transmission and switch on/off output stages to 90% of final level T6817 10 < 150°C; unless otherwise specified, all values refer to GND pins. ...

Page 11

... 100 pF – 100 Input register bit 14 9 (SCT) = high Input register bit 14 9 (SCT) = low 5 6 – T6817 Symbol Min. Typ. Max. t 200 ENDO t 200 DISDO t 100 DOf t 100 DOr t 200 DOVal t 225 CSSethl t 225 ...

Page 12

... Figure 9-1. Serial Interface Timing with Chart Numbers CLK 3 DI CLK DO Inputs DI, CLK, CS: High level = 0.7 V Output DO: High level = 0.8 V T6817 low level = 0 low level = 0 4670D–BCD–04/07 ...

Page 13

... L S protection Vcc V S VCC 19 Control UV- protection logic GND Power- reset GND Vcc 10 GND 11 Fault detect Thermal GND 13 protection GND 20 17 LS1 and V be connected as close T6817 Vs BYT41D VS V Batt Vcc ...

Page 14

... Ordering Information Extended Type Number T6817-TKSY T6817-TKQY 12. Package Information 0.25 ±0. Drawing-No.: 6.543-5056.01-4 Issue: 1; 10.03.04 T6817 14 Package Remarks SSO20 Power package, tube, Pb-free SSO20 Power package, taped and reeled, Pb-free 6.75 -0.25 0.65 ±0.05 5.85 ±0. 5.4 ±0.2 4.4 ±0.1 6.45 ±0.15 Package: SSO20 Dimensions in mm technical drawings ...

Page 15

... History Put datasheet in a new template Pb-free logo on page 1 deleted Table 8 “Electrical Characteristics” number 5.11 on page 9 changed Pb-free logo on page 1 added Table “Ordering Information” on page 14 changed Put datasheet in a new template Table “Electrical Characteristics” rows 5.15 and 5.16 changed T6817 15 ...

Page 16

... Atmel products are not suitable for, and shall not be used in, automotive applications. Atmel’s products are not intended, authorized, or warranted for use as components in applications intended to support or sustain life. © 2007 Atmel Corporation. All rights reserved. Atmel marks or trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others. Atmel Operations Memory ...

Related keywords