sky65013 Skyworks Solutions, Inc., sky65013 Datasheet - Page 3

• Manufacturer Part Number: sky65013
• Description: Sky65013-214lf Ingap General-purpose Amplifier Lf?6 Ghz
• Manufacturer: Skyworks Solutions, Inc.

Absolute Maximum Ratings
Performance is guaranteed only under the conditions listed in the specifications table and is
not guaranteed under the full range(s) described by the Absolute Maximum specifications.
Exceeding any of the absolute maximum/minimum specifications may result in permanent
damage to the device and will void the warranty.
CAUTION: Although this device is designed to be as robust as
Micro-X
RF input power
Supply voltage
Supply current
Power dissipation @ T = 25 °C
Operating temperature
Storage temperature
0.100 (2.54 mm)
0.060 (1.52 mm)
possible, ESD (Electrostatic Discharge) can damage
this device. This device must be protected at all times
from ESD. Static charges may easily produce poten-
tials of several kilovolts on the human body or
equipment, which can discharge without detection.
Industry-standard ESD precautions must be employed
at all times.
Characteristic
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
200310 Rev. C • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice. • April 7, 2006
0.092 (2.34 mm)
0.085 (2.16 mm)
0.006 (0.15 mm)
0.020 (0.51 mm)
0.020 (0.51 mm)
-65 °C to +125 °C
-40 °C to +85 °C
0.026 (0.660 mm)
600 mW
15 dBm
120 mA
Value
5 V
Pin Out (Top View)
Pin Descriptions
Recommended Solder Reflow Profiles
Refer to the
Application Note.
Tape and Reel Information
Refer to the
Tape and Reel Package Orientation”
Pin Number
2, 4
1
3
“Discrete Devices and IC Switch/Attenuators
“Recommended Solder Reflow Profile”
Pin Name
Output
1
Input
GND
Equipotential point – Internal circuit com-
mon, which must be connected to the PCB
ground or common via the lowest possible
impedance.
RF input – RF input with 50 Ω nominal
input impedance. An internally generated
DC voltage is present at this pin, so an
external DC block should be used to
connect this pin to the external circuit.
RF output – DC supply voltage input and
RF output with 50 Ω nominal output
impedance. The nominal voltage required
at this pin is listed in the Electrical
Specifications Table. Supply current is
determined by an external resistor
connected between the DC power supply
and this pin.
4
2
DATA SHEET • SKY65013-214LF
Application Note.
Description
3
3