maapgm0041 Tyco Electronics, maapgm0041 Datasheet - Page 5

• Manufacturer Part Number: maapgm0041
• Description: Amplifier, Power, 1.3w 11.5 - 15.0 Ghz
• Manufacturer: Tyco Electronics

5
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
Amplifier, Power, 1.3W
11.5—15.0 GHz
Assembly Instructions:
This flange mount style package provides a robust interface between a highly integrated GaAs MMIC device and a circuit board
which may be assembled using conventional surface mount techniques. A thin shim made of a thermally and electrically
conductive, ductile material should be used prior to installation of the CR-15 to improve the thermal and electrical performance of
the package to housing interface. Refer to M/A-COM Application Note #M567* for more information .
For applications where surface mount components are to be installed after the CR-15 installation, this package will not be
damaged when subjected to typical convection or IR oven reflow profiles. Refer to M/A-COM Application Note #M538* for
maximum allowable reflow time and temperature. Alternatively, the package leads may be individually soldered. Whether an iron
or hot gas soldering equipment is used, care should be taken to insure that the temperature is well controlled and electric static
discharge (ESD) safe.
Biasing Notes:
V
♦
♦
GG
(See Electrical Characteristics - Page 2)
The 100pF bypass capacitors must be placed as close to the V
(recommended < 100 mils).
A negative bias must be applied to V
R
G
* Application Notes can be found by going to the Site Search Page on M/A-COM’s web page
0.1 μF
(http://www.macom.com/search/search.jsp) and searching for the required Application Note.
100 pF
Figure 6. Recommended Bias Configuration
RF
IN
GG
before applying a positive bias to V
GG
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macom.com for additional data sheets and product information.
and V
DD
RF
DD
OUT
pins as possible
to prevent damage to the amplifier.
100 pF
0.1 μF
Pin Number
V
10
1
2
3
4
5
6
7
8
9
DD
Preliminary Information
MAAPGM0041
No Connection
No Connection
No Connection
No Connection
No Connection
No Connection
Description
RF OUT
RF IN
V
V
GG
DD
903208 —