m52746sp Mitsumi Electronics, Corp., m52746sp Datasheet - Page 14

• Manufacturer Part Number: m52746sp
• Description: Bus Controlled 3ch Video Pre-amp For Crt Display Monitor
• Manufacturer: Mitsumi Electronics, Corp.

Note43) Control the main contrast (00H) in order that the amplitude of output signal is 4.0Vp-p.
output
Note44) Measure the time needed for the input pulseto fall from 90 % to 10 % (Tf1) and for the
output
Note45) Turn down the SG5 input level gradually from 5.0Vp-p, monitoring the waveform output.
Note46) Decrease the SG5 pulse width gradually from 0.5us, monitoring the output. Measure the
Note47) Measure the pedestal voltage at 25 C. The measured value is called PDC1.
Note48) Measure the pedestal voltage at 25 C. The measured value is called PDC1.
Control the brightness (V1) in order that the Black level of output signal is 2.0V.
Measure the time needed for the input pulse to rise from 10 % to 90 % (Tr1) and for the
pulse to fall from 90 % to 10 % (Tf2) with an active prove.
Pulse characteristics Tf is calculated by the equations below :
Measure the top level of input pulse when the output pedestal voltage turn decrease with
unstable.
SG5 pulse width (a point of 1.5V) when the output pedestal voltage turn decrease with
unstable.
Measure the pedestal voltage at temperature of -20 C. The measured value is called
PDC2.
Pedestal voltage temperature characteristics 1 is calculated by the equation below:
Measure the pedestal voltage at temperature of 75 C. The measured value is called PDC3.
Pedestal voltage temperature characteristics 2 is calculated by the equation below:
pulse to rise from 10 % to 90 % (Tr2) with an active prove.
Pulse characteristics Tr is calculated by the equations below :
Tr =
Tf =
0%
100%
(Tf2) - (Tf1)
(Tr2) - (Tr1)
Tr1
or
Tr2
2
2
MITSUBISHI
PDCH=PDC1-PDC2
PDCL=PDC1-PDC3
BUS CONTROLLED 3CH VIDEO PRE-AMP FOR CRT DISPLAY MONITOR
(nsec)
2
2
(nsec)
Tf1
or
Tf2
90%
10%
MITSUBISHI< LINEAR IC >
M52746SP
14
25