lc895198 Sanyo Semiconductor Corporation, lc895198 Datasheet - Page 10

• Manufacturer Part Number: lc895198
• Description: 32? Atapi Ic With On-chip Dram
• Manufacturer: Sanyo Semiconductor Corporation

Continued from preceding page.
• Unused ("NC") pins must be left open.
• Pins whose name begin with a Z operate with inverted (negative) logic.
• V
• Applications must supply 5.0 V to V
SS0
Pin No.
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
is the logic system ground and V
This catalog provides information as of November, 1999. Specifications and information herein are
subject to change without notice.
Specifications of any and all SANYO products described or contained herein stipulate the performance,
characteristics, and functions of the described products in the independent state, and are not guarantees
of the performance, characteristics, and functions of the described products as mounted in the customer’s
products or equipment. To verify symptoms and states that cannot be evaluated in an independent device,
the customer should always evaluate and test devices mounted in the customer’s products or equipment.
SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all
semiconductor products fail with some probability. It is possible that these probabilistic failures could
give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire,
or that could cause damage to other property. When designing equipment, adopt safety measures so
that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective
circuits and error prevention circuits for safe design, redundant design, and structural design.
In the event that any or all SANYO products (including technical data, services) described or contained
herein are controlled under any of applicable local export control laws and regulations, such products must
not be exported without obtaining the export license from the authorities concerned in accordance with the
above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system,
or otherwise, without the prior written permission of SANYO Electric Co., Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the “Delivery Specification”
for the SANYO product that you intend to use.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not
guaranteed for volume production. SANYO believes information herein is accurate and reliable, but
no guarantees are made or implied regarding its use or any infringements of intellectual property rights
or other rights of third parties.
ATPINSEL
AUDIOCK
ZRESET
ZCS3FX
ZDASP
ZHRST
TEST1
TEST0
V
V
V
V
V
V
V
V
V
V
V
V
Pin
DD1
DD1
DD0
DD1
DD1
DD0
DD0
DD0
SS0
SS0
SS0
SS0
DD0
SS1
Type
and 3.3 V to V
B
P
P
P
P
P
P
P
P
P
P
P
I
I
I
I
I
I
I
I
is the IDE interface driver ground.
ATAPI control signal
3.3 V
3.3 V
5.0 V
3.3 V
IC reset input
3.3 V
Test pin. This pin must be connected to V
ATAPI pin layout selection. This pin must be connected to V
Test pin. This pin must be connected to V
5.0 V
Clock input for the CAV audio block
5.0 V
5.0 V
DD1
.
LC895198
SS
SS
in normal operation.
in normal operation.
Function
DD0
.
PS No. 6237-10/10