sit8102 Fronter Electronics Co., Ltd., sit8102 Datasheet
sit8102
Available stocks
Related parts for sit8102
sit8102 Summary of contents
Page 1
... SiT8102 1 to 200 MHz High Performance Oscillator Features • High frequency stability • ±10 PPM, ±15 PPM, ±20 PPM • ±25 PPM, ±50 PPM, ±100 PPM • Extremely low RMS phase jitter (random) • 0.5 ps (typical) • Wide frequency range • 200 MHz • ...
Page 2
... The output driver strength can be programmed to drive up to 30pF load. Please contact factory for this option. System reliability is also increased with the SiT8102 by elimi- nating the quartz crystal and improved immunity to the environmental effects of vibration, shock, strain, and humidity. ...
Page 3
... SiT8102 DC Electrical Specifications @VDD = 3.3V ±10%, -40 to 85°C Parameter Condition Output Voltage High IOH = -9 mA Output Voltage Low IOL = 9 mA Input Voltage High Pin 1 Input Voltage Low Pin 1 Operating Current Output frequency = 30 MHz load Output frequency = 125 MHz load Standby Current ...
Page 4
... SiT8102 AC Electrical Specifications @VDD = 3.3V ±10%, -40 to 85°C Parameter Condition Clock Output Frequency Frequency Stability Inclusive of initial tolerance, operating temp., rated power supply voltage change, load change Aging First year @ 25 °C Clock Output Duty Cycle Output frequency 125 MHz Output frequency= 125 to 200 MHz ...
Page 5
... RMS Phase Jitter (Random) Output frequency = 75 MHz (900 kHz to 7.5 MHz) Output frequency = 106.25 MHz (637kHz to 10 MHz) Output frequency = 125 MHz (1.875 to 20 MHz) Ordering Information SiT8102A 25E - 123.12345T Part Fam ily “SiT 8102” Revision Letter “A” is the silicon revision Tem perature Range “ ...
Page 6
... SiT8102 [3] Package Information Dimension (mm) 2.5 x 2.0 x 0.85mm 2.5±0.10 0.8 3.2 x 2.5 x 0.85mm 3.2±0.15 5.0 x 3.2 x 0.85mm 5.0±0.15 Land Pattern (recommended) (mm) 1.0 2.1 0.9 2.39 1.2 Page [4] 1.9 1.1 2.2 1.4 2.54 1.5 ...
Page 7
... SiT8102 Package Information [3] (continued) Dimension (mm) 7.0 x 5.0 x 0.85mm 0.85±0.15 Do not Connect the center pad Notes: 3. xxxx top marking denotes manufacturing lot number capacitor of value 0.1 μ F between VDD and GND is recommended. © SiTime Corporation 2008. The information contained herein is subject to change at any time without notice. SiTime assumes no responsibility or liability for any loss, damage or defect of ...