ca2301sr American Opto Plus LED, ca2301sr Datasheet - Page 4

• Manufacturer Part Number: ca2301sr
• Description: American Opto Plus LED A2301SR G/W 2.30???? Single Digit Seven Segment Display
• Manufacturer: American Opto Plus LED

LAMP HANDLING AND APPLICATION PRECAUTIONS
STORAGE
FORMING
SOLDERING
CLEANING
1. Any forming on lead pin must be done before solding, not during or after soldering
2. Avoid applying any stress to resin in order to prevent the epoxy fracture and break on
3. While forming, please use a tie bar cut or equivalent ot hold or bend the pin.
4. 2mm from the base of resin is the minimum distance for the place bending the lead pin
5. Avoid bending the lead pin at the same point twice or more
1. No stress can be applied to lead pins when they are heated, otherwise disconnection may
2. When an LED is mounted into a P.C. board, pitch spacing should be aligned carefully to
3. Mounting direction (electrode direction) of SMD LED and Display should be
4. After soldering, don’t bend the PCB
1. Avoid using any unspecified chemical solvent to clean LED. For example,
2. Any cleaning method can only be taken under normal temperature in one minute or less if
3. Special attention should be taken when using any chemicals for claning because some
1. It is recommended to store the products in the following conditions:
bonding wire.
Trichoroethylene, Chlorosen, Acetone, and Diflon S3MC.
it is required
chemicals may damage the surface of epoxy.
occur.
avoid causing any stress to the lead wires.
perpendicular to direction of PCB curve
a. Humidity: 60% RH Max
b. Shelf life in sealed bag: 3 month < 40°C and 90% RH
Temperature: 5°C ~ 40°C (41°F ~ 105°F)
American Opto Plus LED
2.30’’ Single Digit Seven Segment Display
C/A2301SR G/W
2.30 inch (56.90 mm) height
Low power consumption
RoHS Compliance
Case mold type