C-127-1250-TDFB3-SSC2 SOURCE [Source Photonics, Inc.], C-127-1250-TDFB3-SSC2 Datasheet
C-127-1250-TDFB3-SSC2
Related parts for C-127-1250-TDFB3-SSC2
C-127-1250-TDFB3-SSC2 Summary of contents
Page 1
... Note 10 seconds on leads only Unit V ºC Mbps Notes Output Power is coupled into a 9/125 µm single mode fiber λ = 1xxx nm -20 dB width CW 5mW o 20% to 80% Values 20% to 80% Values 7 Measured with 2 -1 PRBS with 72 ones and 72 zeros. (3.3V) ...
Page 2
... SDL Signal Detect Output Voltage-High V SDH Signal Detect Output Voltage-Low V V SDL- cc Signal Detect Output Voltage-High V V SDH- cc 1.25 Gbps CWDM Single Mode Transceiver C-1xx-1250(C)-TDFB3-SSC2 < 3.3V) CC Typical Max Unit Maximum current is specified at Vcc= Maximum @ - - 260 mA maximum temperature - - µ 350 µ -1. -0.74 V < ...
Page 3
... See recommended circuit schematic Warnings 8 TD+ See recommended circuit schematic 9 TxGND Directly connect this pin to the transmitter ground plane 1.25 Gbps CWDM Single Mode Transceiver C-1xx-1250(C)-TDFB3-SSC2 Receiver Signal Ground Receiver Data Out Receiver Data Out Bar Signal Detect Receiver Power Supply ...
Page 4
... The split-loaded terminations for ECL signals need to be located at the input of devices receiving those ECL signals. The power supply filtering is required for good EMI performance. Use short tracks from the inductor L1/L2 to the module Rx Vcc. A GND plane under the module is required for good EMI and sensitivity performance. ...
Page 5
... Package Diagram 1.25 Gbps CWDM Single Mode Transceiver C-1xx-1250(C)-TDFB3-SSC2 5 (3.3V) ...
Page 6
... Luminent customers using or selling products for use in such applications their own risk and agree to fully defend and indemnify Luminent for any damages resulting from such use or sale. ...