PIC18F2510 MICROCHIP [Microchip Technology], PIC18F2510 Datasheet - Page 315

• Manufacturer Part Number: PIC18F2510
• Description: 28/40/44-PIN FLASH MICROCONTROLLERS WITH 10-BIT A/D AND NANO WATT TECHNOLOGY
• Manufacturer: MICROCHIP [Microchip Technology]

25.0
Absolute Maximum Ratings
Ambient temperature under bias.............................................................................................................-40°C to +125°C
Storage temperature .............................................................................................................................. -65°C to +150°C
Voltage on any pin with respect to V
Voltage on V
Voltage on MCLR with respect to V
Total power dissipation (Note 1) ...............................................................................................................................1.0W
Maximum current out of V
Maximum current into V
Input clamp current, I
Output clamp current, I
Maximum output current sunk by any I/O pin..........................................................................................................25 mA
Maximum output current sourced by any I/O pin ....................................................................................................25 mA
Maximum current sunk by all ports .......................................................................................................................200 mA
Maximum current sourced by all ports ..................................................................................................................200 mA
 2004 Microchip Technology Inc.
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above those
indicated in the operation listings of this specification is not implied. Exposure to maximum rating conditions for
extended periods may affect device reliability.
Note 1: Power dissipation is calculated as follows:
2: Voltage spikes below V
ELECTRICAL CHARACTERISTICS
Pdis = V
latch-up. Thus, a series resistor of 50-100
RE3 pin, rather than pulling this pin directly to V
DD
with respect to V
DD
IK
OK
(V
x {I
DD
I
SS
(V
DD
< 0 or V
pin ..............................................................................................................................250 mA
O
pin ...........................................................................................................................300 mA
– ∑ I
< 0 or V
SS
OH
I
SS
SS
SS
> V
......................................................................................................... -0.3V to +7.5V
(†)
} + ∑ {(V
(Note 2) ......................................................................................... 0V to +13.25V
O
at the MCLR/V
(except V
DD
> V
)
DD
DD
)
DD
– V
Preliminary
and MCLR) ................................................... -0.3V to (V
OH
PP
) x I
should be used when applying a “low” level to the MCLR/V
/RE3 pin, inducing currents greater than 80 mA, may cause
OH
SS
} + ∑(V
.
OL
PIC18F2X1X/4X1X
x I
OL
)
DS39636A-page 313
DD
+ 0.3V)
20 mA
20 mA
PP
/