TMC246/A ETC2 [List of Unclassifed Manufacturers], TMC246/A Datasheet - Page 17

• Manufacturer Part Number: TMC246/A
• Description: High Current Microstep Stepper Motor Driver with sensorless stall detection, protection / diagnosis and SPI Interface
• Manufacturer: ETC2 [List of Unclassifed Manufacturers]

TMC246 DATA SHEET (V2.01 / Sep. 14th, 2005)
Slope Control Resistor
The output-voltage slope of the full bridge outputs can be controlled to reduce noise on the power
supply and on the motor lines and thus electromagnetic emission of the circuit. It is controlled by an
external resistor at the SLP pin.
Operational range:
The SLP-pin can directly be connected to AGND for the fastest output-voltage slope (respectively
maximum output current). In most applications a minimum external resistance of 10 KΩ is
recommended to avoid unnecessary high switching spikes.
Only for non-A-types the slope on the lower transistors is fixed (corresponding to a 5KΩ to 10KΩ
slope control resistor). For applications where electromagnetic emission is very critical, it might be
necessary to add additional LC (or capacitor only) filtering on the motor connections.
For these applications emission is lower, if only slow decay operation is used.
Please remark, that there is a trade off between reduced electromagnetic emissions (slow slope) and
high efficiency because of low dynamic losses (fast slope).
The following table and graph depict typical behavior measured from 15% of output voltage to 85% of
output voltage. However, the actual values measured in an application depend on multiple parameters
and may stray in a user application.
Example for slope settings
t
30ns
60ns
110ns
245ns
460ns
Copyright © 2005, TRINAMIC Motion Control GmbH & Co KG
SLP
500
200
100
typ.
50
20
10
0kΩ ≤ R
0
R
2.2KΩ
10KΩ
22KΩ
51KΩ
100KΩ
SLP
1
SLP
≤ 100kΩ
2
5
R
SLP
10
in KOhm
20
50
100
17