MAX2371 MAXIM [Maxim Integrated Products], MAX2371 Datasheet
MAX2371
Available stocks
Related parts for MAX2371
MAX2371 Summary of contents
Page 1
... The MAX2371/MAX2373 can work over the frequency range from 100MHz to 1GHz. In practice, only a narrow band is needed in each application, so different matching circuits can be applied. The devices are dynamically con- ...
Page 2
... Digital Input Logic Low V Logic Pin Impedance AGC Pin Impedance AC ELECTRICAL CHARACTERISTICS (MAX2371/MAX2373 EV Kits 2.65V to 3.3V, RX_EN = high 2.775V; for MAX2371 f = 150MHz, for MAX2373 f RF PARAMETER LNA AND AGC AMP CHARACTERISTICS Radio Frequency Range (Note 2) Input Return Loss (S11) (Note 3) Reverse Isolation (S12) ...
Page 3
... CC AGC to 2.575V +25°C A RF_ATTN = low 1.625V AGC RF_ATTN = high 1.625V AGC MAX2371 RF_ATTN = high to low, LNA_I = high MAX2373 = -30dBm for both tones (MAX2371 -30dBm for both tones (MAX2373 -40°C to +85°C. Typical values are MIN TYP MAX 1.8 2.2 5.0 7 ...
Page 4
... V (V) AGC S11, S22, S12 vs. V AGC 0 S11 -10 S22 -20 S11 RF_ATTN = HIGH RF_ATTN = LOW -30 -40 S12 -50 -60 1.2 1.7 2.2 2.7 V (V) AGC = +25°C. For MAX2371 150MHz IIP3 vs. V AGC 25 RF_ATTN = HIGH -40° +85° +25° -10 RF_ATTN = LOW -15 1 ...
Page 5
... AGC S11, S22, S12 vs. V AGC 0 -5 S11 -10 -15 S22 -20 -25 S11 -30 RF_ATTN = HIGH RF_ATTN = LOW -35 -40 S12 -45 -50 1.2 1.7 2.2 V (V) AGC = +25°C. For MAX2371 150MHz IIP3 vs. V AGC 20 RF_ATTN = HIGH -40° +25° -10 RF_ATTN = LOW -15 1.3 1.4 1.5 1 ...
Page 6
... LNAs with Step Attenuator and VGA Table 1. MAX2371 S-Parameters (V = 2.775V, RX_EN = high, LNA_I = high, RF_ATTN = low LNA (S11) FREQUENCY (MHz) MAGNITUDE PHASE 10 0.943409 -4.8477 100 0.746965 -29.9420 150 0.728794 -35.6990 200 0.705066 -43.4190 300 0.704636 -55.1180 400 0.719615 -65.2420 500 ...
Page 7
... Table 3. MAX2371 Typical Noise Parameters (V = 2.775V, RX_EN = high, LNA_I = high, RF_ATTN = low FREQUENCY (MHz) NF MIN 130 0.84 140 0.83 150 0.82 160 0.81 170 0.81 180 0.81 ...
Page 8
... Detailed Description The MAX2371/MAX2373 are single-channel, single- ended, low-noise amplifiers with two gain modes and continuous automatic gain control (AGC) in both modes. The devices are intended as low-noise gain 8 _______________________________________________________________________________________ = -30dBm +25°C, data from design simulation ⎜ ...
Page 9
... LNAs with Step Attenuator and VGA The MAX2371/MAX2373 can be turned off in transmit or battery-save standby mode. The receive-enable pin (RX_EN) also can turn off the devices even if V removed, because multiple LNAs can be connected to the same V for multiband applications. CC The devices allow external matching networks to configure operation in a wide frequency range ...
Page 10
... Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. _____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 © 2006 Maxim Integrated Products PRECISION RF_V GND CC MAX2371 MAX2373 RF AGC LNA ATTENUATOR AMP EXPONENTIAL ...