M52390 Mitsubishi, M52390 Datasheet - Page 14

• Manufacturer Part Number: M52390
• Description: NTSC/PAL ENCODER
• Manufacturer: Mitsubishi

(9) Setting of V DL and Ys DL in superimpose mode
1) V DL is used to adjust the timing of RGB encode signal and
2) Ys DL is used to adjust the timing of RGB encode signal and Ys
3) In case that signals are input to C.SYNC IN, RGB IN, VIDEO IN
(7) Driving of input pins
(8) I/O relation between sync signal and burst signal
10
2
VIDEO IN signal.
IN signal.
or Ys IN at the same timing, set V DL and Ys DL based on the
delay volume as below.
Drive pins
are clamped by IC input.
VIDEO OUT
during the period V
C.Sync IN
(Ts:Hi)
V DL = Y DL (Refer to (4)) + 10 (nsec)
Ys DL = Y DL - 10 (nsec)
9
,
16 17
,
and
18
I/O relation between sync signal and burst signal
at low impedance because they
Sync signal
MITSUBISHI ICs (AV COMMON)
Burst signal
NTSC/PAL ENCODER
M52390FP