SFSL4.5MDB YAMAR [Yamar Electronics Ltd.], SFSL4.5MDB Datasheet
SFSL4.5MDB
Available stocks
Related parts for SFSL4.5MDB
SFSL4.5MDB Summary of contents
Page 1
Proprietary and Confidential Information of YAMAR Electronics Ltd. ISL40 - Independent DC-LIN Slave YAMAR For Asynchronous Communication Ele c tro Preliminary Data Sheet This information is preliminary and may be changed without notice 1 GENERAL The ...
Page 2
Proprietary and Confidential Information of YAMAR Electronics Ltd. 2.2 Channels and Network The ISL40 operates over one of two preset selectable channels (frequencies) using a single line such as the vehicle’s battery power line. A SIG40 master and up to ...
Page 3
Proprietary and Confidential Information of YAMAR Electronics Ltd. 3 OPERATION The following paragraph describes the operation of the ISL40 device. 3.1 Protocol The device responds to five types of LIN messages: Write, Read, Read Change, Sleep and Change Frequency. When ...
Page 4
Proprietary and Confidential Information of YAMAR Electronics Ltd. Read-state: Detecting Read-state header causes the ISL40 to send its input pins current state. The Read-state message from the master consists of 3 bytes - sync break, sync field and identifier. The ...
Page 5
Proprietary and Confidential Information of YAMAR Electronics Ltd. Sync break Sync Field Change Frequency message: This type of message consists of 5 bytes - sync break, sync field, “FE” Hex, “00” Hex and checksum. The change frequency message identifier is ...
Page 6
Proprietary and Confidential Information of YAMAR Electronics Ltd. mode. If nSleep pin is low upon waking up, the local device that lowered it must raise the nSleep back high. Wake INH T1 DC-BUS HDO T1 = 30uS-62uS T2 = 92uS-124uS ...
Page 7
Proprietary and Confidential Information of YAMAR Electronics Ltd. 4 ISL40 SIGNALS Device signals are defined in table 4.1. Control signals HDO CMOS nSleep CMOS INH CMOS Wake CMOS nReset CMOS_Reset+PU I InterfHop CMOS + PD Interfer CMOS Front-end signals RxOn ...
Page 8
Proprietary and Confidential Information of YAMAR Electronics Ltd. 4.1 Application interface 4.1.1 HDO The HDO pin outputs the data that is being received from the DC-BUS. It can be used to monitor the incoming data. 4.1.2 SigIn[0:3] Four input signals ...
Page 9
Proprietary and Confidential Information of YAMAR Electronics Ltd. 4.3.2 InterfHop When high, a detection of interference, switches the operating frequency the new frequency, no reception occurred for 2 sec, the operating frequency is switched back. For designs with ...
Page 10
... Type 32.768KHz +/-20 ppm 12.5 pF 50K Ohm (max.) 1uW (max.) 50,000 (max.) +25ºC +/- 5ºC -0.04 ppm/ºC² (max.) +/-3 ppm in first year (max.) -40º 85ºC -55º 125ºC 10 Murata Oscilent part # part # SFSH3.58MCB SFSL4.5MDB 773-0045 SFSL5.5MDB 773-0055 SFSL6.0MDB 773-0060 SFSL6.5MDB 773-0065 Value DS-ISL40 R1.6 ...
Page 11
Proprietary and Confidential Information of YAMAR Electronics Ltd. 4.9 PLL Power Pins VccPLL should be connected to Vcc. GndPLL should be connected to ground. The PLL supply has to be sufficiently powered, to avoid any fluctuations of power supply. A ...
Page 12
Proprietary and Confidential Information of YAMAR Electronics Ltd. 5 ELECTRICAL PARAMETERS 5.1 Absolute Maximal Rating Ambient Temperature under bias Storage Temperature Voltage on any pin with respect to Vss (except Vdd and ~Reset) -0.6V to Vdd+0.6V Voltage on Vdd with ...