HDSP-253X HP [Agilent(Hewlett-Packard)], HDSP-253X Datasheet - Page 9

• Manufacturer Part Number: HDSP-253X
• Description: Eight Character 5 mm Smart Alphanumeric Display
• Manufacturer: HP [Agilent(Hewlett-Packard)]

Display Internal Block
Diagram
Figure 1 shows the internal block
diagram of the HDSP-253X
display. The CMOS IC consists of
an 8 byte Character RAM, an 8 bit
Character Ram
Figure 2 shows the logic levels
needed to access the
HDSP-253X Character RAM.
During a normal access the CE =
“0” and either RD = “0” or WR =
“0”. However, erroneous data may
be written into the Character RAM
if the Address lines are unstable
when CE = “0” regardless of the
logic levels of the RD or WR lines.
Address lines A
select the location in the Charac-
ter RAM. Two types of data can
be stored in each Character RAM
location: an ASCII code or a UDC
RAM address. Data bit D
to differentiate between the ASCII
character and a UDC RAM
address. D
decoder and D
UDC RAM. D
input ASCII data and D
used to input a UDC address.
Character RAM
Flash RAM
User-Defined Character RAM
(UDC RAM)
User-Defined Character
Address Register
(UDC Address Register)
Control Word Register
7
= 0 enables the ASCII
0
-D
7
0
-A
= 1 enables the
6
are used to
2
are used to
0
-D
7
is used
3
are
Flash RAM, a 128 character ASCII
decoder, a 16 character UDC
RAM, a UDC Address Register, a
Control Word Register and the
refresh circuitry necessary to
synchronize the decoding and
Figure 2. Logic Levels to Access the Character RAM.
This RAM stores either ASCII character data or a UDC RAM
address.
This is a 1 x 8 RAM which stores Flash data.
This RAM stores the dot pattern for custom characters.
This register is used to provide the address to the UDC RAM when
the user is writing or reading a custom character.
This register allows the user to adjust the display brightness, flash
individual characters, blink, self test or clear the display.
9
driving of eight 5 x 7 dot matrix
characters. The major user
accessible portions of the display
are listed below: