1778410M2FCB0 Vishay, 1778410M2FCB0 Datasheet - Page 8

• Manufacturer Part Number: 1778410M2FCB0
• Description: Interference Suppression Film Capacitors Mkp Radial Potted Type
• Manufacturer: Vishay

F1778-2 X2
Vishay Roederstein
APPLICATION NOTES
• For X2 electromagnetic interference suppression in standard across the line applications (50 Hz/60 Hz) with a maximum
• For series impedance applications we refer to application note www.vishay.com/doc?28153
• These capacitors are not intended for continuous pulse applications. For these situations, capacitors of the AC and pulse
• The maximum ambient temperature must not exceed 110 °C (125 °C for less than 1000 h) for C ≤ 470 nF
• Rated voltage pulse slope:
INSPECTION REQUIREMENTS
General Notes:
• Sub-clause numbers of tests and performance requirements refer to the “Sectional Specification, IEC Publication
Group C Inspection Requirements
www.vishay.com
8
10
10
10
SUB-CLAUSE NUMBER AND TEST
SUB-GROUP C1A PART OF SAMPLE OF
SUB-GROUP C1
4.1
4.3
4.4
4.19 Component solvent resistance
mains voltage of 310 Vac.
programs must be used.
If the pulse voltage is lower than the rated voltage, the values of the specific reference data can be multiplied by 435 Vdc and
divided by the applied voltage.
IEC 60384-14 ed-3 and Specific Reference Data”.
6
5
4
0
Insulation resistance as a function of ambient temperature
Dimensions (detail)
Initial measurements
Robustness of terminations
Resistance to soldering heat
20
40
(typical curve)
60
For technical questions, contact: [e-mail]
80
Interference Suppression Film Capacitors
CONDITIONS
Capacitance
Tangent of loss angle:
For C ≤ 1 µF at 10 kHz
For C > 1 µF at 1 kHz
Tensile: load 10 N; 10 s
Bending: load 5 N; 4 x 90°
No pre-drying
Method: 1A
Isopropylalcohol at room temperature
Method: 2
Solder bath: 280 °C ± 5 °C
Duration: 10 s
Immersion time: 5 min ± 0.5 min
Recovery time:
Min. 1 h, max. 2 h
T
amb
100
(°C)
MKP Radial Potted Type
and 110 °C for C > 470 nF.
PERFORMANCE REQUIREMENTS
As specified in section “General Data” of this
specification
No visible damage
Document Number: 27610
Revision: 04-Mar-09