DS1818R-10-U Maxim Integrated, DS1818R-10-U Datasheet - Page 2

• Manufacturer Part Number: DS1818R-10-U
• Description: Supervisory Circuits
• Manufacturer: Maxim Integrated
• Series: DS1818r

Specifications of DS1818R-10-U

• Number Of Voltages Monitored: 1
• Monitored Voltage: 1 V to 5.5 V
• Undervoltage Threshold: 2.8 V
• Overvoltage Threshold: 2.97 V
• Output Type: Active Low, Open Drain
• Manual Reset: Not Resettable
• Watchdog: No Watchdog
• Battery Backup Switching: No Backup
• Power-up Reset Delay (typ): 250 ms
• Supply Voltage - Max: 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOT-23
• Chip Enable Signals: No
• Minimum Operating Temperature: - 40 C
• Power Fail Detection: Yes
• Supply Current (typ): 35 uA
• Supply Voltage - Min: 1 V
• Part # Aliases: 90-1818R-U10

OPERATION - POWER MONITOR
The DS1818 provides the functions of detecting out-of-tolerance power supply conditions and warning a
processor-based system of impending power failures. When V
signal is asserted. On power-up,
reached the selected tolerance. This allows the power supply and microprocessor to stabilize before
is released.
BLOCK DIAGRAM (OPEN-DRAIN OUTPUT) Figure 1
APPLICATION EXAMPLE Figure 2
OPERATION - PUSHBUTTON RESET
The DS1818 provides a pushbutton switch for manual reset control. When the DS1818 is not in a reset
cycle, a pushbutton reset can be generated by pulling the
pushbutton is held low, the
the pushbutton is released. See Figure 2 for an application example and Figure 3 for the timing diagram.
TIMING DIAGRAM: PUSHBUTTON RESET Figure 3
RST
RST
is forced active low and will remain active low for about 150 ms after
is kept active for approximately 150 ms after the power supply has
2 of 5
RST
CC
is detected as out-of-tolerance, the
pin low for at least 1 ms. When the
DS1818
RST
RST