S-24CS01AFJ-TB-G Seiko Instruments, S-24CS01AFJ-TB-G Datasheet - Page 27
![IC EEPROM 1KBIT 400KHZ 8SOP](/photos/6/58/65866/8-sop_pkg_sml.jpg)
S-24CS01AFJ-TB-G
Manufacturer Part Number
S-24CS01AFJ-TB-G
Description
IC EEPROM 1KBIT 400KHZ 8SOP
Manufacturer
Seiko Instruments
Datasheet
1.S-24CS01AFT-TB-G.pdf
(47 pages)
Specifications of S-24CS01AFJ-TB-G
Format - Memory
EEPROMs - Serial
Memory Type
EEPROM
Memory Size
1K (128 x 8)
Speed
400kHz
Interface
I²C, 2-Wire Serial
Voltage - Supply
1.8 V ~ 5.5 V
Operating Temperature
-40°C ~ 85°C
Package / Case
8-SOP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
S-24CS01AFJ-TB-G
Manufacturer:
SEIKO
Quantity:
576
Rev.4.5
8. Trap: E
9. Trap: E
10. Trap: Severe environments
When the E
“write” operation is aborted.
When the E
write”, 8-bit of data received normally before receiving the stop condition signal can be written.
When write data is input more than defined page size at page write operation, for example, S-24CS04A
(which can be executed 16-byte page write) is received data more than 17 byte, 8-bit data of the 17th byte
is over written to the first byte in the same page. Data over the capacity of page address cannot be written.
Absolute maximum ratings: Do not operate these ICs in excess of the absolute maximum ratings (as listed
on the data sheet). Exceeding the supply voltage rating can cause latch-up.
Operations with moisture on the E
Especially, in occasions like picking the E
sure that not remain frost on E
Also attention should be paid in using on environment, which is easy to dew for the same reason.
_00
“page write”
receiving the defined data value (less than 8-bit) to SCL pin
2
2
PROM operation and write data in case that write data is input more than defined page size at
PROM operation in case that the stop condition is received during write operation before
2
2
PROM receives the stop condition signal compulsorily, during receiving 1 byte of write data,
PROM receives the stop condition signal after receiving 1 byte or more of data for “page
2
PROM pin to prevent malfunction by short-circuit.
2
PROM pins may occur malfunction by short-circuit between pins.
Seiko Instruments Inc.
2
PROM up from low temperature tank during the evaluation. Be
2-WIRE CMOS SERIAL E
S-24CS01A/02A/04A/08A
2
PROM
27