MIKROE-451 mikroElektronika, MIKROE-451 Datasheet - Page 2

• Manufacturer Part Number: MIKROE-451
• Description: Development Boards & Kits - PIC / DSPIC dsPIC READY3 BOARD 28 PIN DSPIC30F
• Manufacturer: mikroElektronika

Specifications of MIKROE-451

• Rohs: yes
• Product: Development Boards
• Core: dsPIC
• Interface Type: IDC10, UART, USB
• Operating Supply Voltage: 8 V to 16 V, 5 V
• Data Bus Width: 16 bit
• Dimensions: 138.3 mm x 73.74 mm
• For Use With: dsPIC30F

MikroElektronika
dsPIC Ready3
The dsPIC Ready3 additional board is used to experiment with dsPIC ® microcontrollers in DIP28 package.
Key features:
How to connect the board?
The dsPIC Ready3 board features five 2x5 connectors (CN1 - CN5) that enable connection between the pins of the
microcontroller plugged into the appropriate socket on the board and external devices. A 2x5 connector CN6 is used
to connect the dsPICFlash programmer to the microcontroller pins used for programming. A USB connector CN51
enables connection between the additional board and a PC via the UART module. In order to enable USB-UART
communication, it is necessary to place the appropriate switch on the DIP switch SW1 to the ON position. By doing
this, the RX and TX pins of the USB-UART module are connected to the appropriate pins of the microcontroller. The
additional board is powered with a voltage in a range between 8 and 16V AC/DC via the CN8 connector.
How to use the board?
In order to use the dsPIC Ready3 additional board, it is first necessary to place a microcontroller in DIP28 package
into one of two appropriate socket supplied on the board. The microcontroller is programmed with the dsPICFlash
programmer that is plugged via its IDC10 connector into a 2x5 connector CN6 supplied on the board. In order to reset
the microcontroller, just press the RESET button. When the programming process is finished, it is necessary to place
jumpers over the 2x5 connector CN6, Figure 1.
- Data transfer via USB-UART communication;
- Programming via the external programmer;
- Pads;
- 8 to 16V AC/DC power supply voltage;
Figure 1: dsPIC Ready3 additional board