AS1107PL austriamicrosystems, AS1107PL Datasheet

Page 1

... Figure 1. AS1106, AS1107 - Typical Application Diagram 9.53kΩ I/O LOAD/CSN I/O SCK Micro- processor www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 2 Key Features 10MHz SPI-, QSPI-, Microwire-Compatible Serial I/O Individual LED Segment Control Segment Blinking Control (can be synchronized across multiple drivers) Hexadecimal- or BCD-Code/No-Decode Digit Selection 3µA Low-Power Shutdown Current (typ; data retained) Extremely Low Operating Current 0 ...

Page 2

... Figure 2. DIP and SO Pin Assignments (Top View) 4.1 Pin Descriptions Table 1. Pin Descriptions Pin Number Pin Name 1 DIN 10, DIG 0:DIG GND 12 LOAD/CSN 13 CLK 14, 15, 16, 17, 20, SEG A:SEG G, SEG DP 21, 22 ISET 19 VDD 24 DOUT www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 DIN 1 24 DOUT DIG SEG D DIG SEG DP GND 4 21 SEG E DIG SEG C DIG VDD ...

Page 3

... Continuous Power Dissipation (TA = +85°C) Narrow plastic DIP Wide SOIC Temperature Ranges and Storage Conditions Storage Temperature Range Package Body Temperature (Wide SOIC) 1 Humidity 1 Moisture Sensitive Level 1. only valid for the SOIC 24-pin package www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 Electrical Characteristics on page 4 Min Max Units -0 -0 ...

Page 4

... IH IL Logic High Input Voltage V IH Logic Low Input Voltage V IL Output High Voltage V OH Output Low Voltage V OL ΔV Hysteresis Voltage I www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 = (unless otherwise specified). AMB MIN MAX Conditions All digital inputs GND +25ºC AMB R = open circuit. SET All segments and decimal point on; ...

Page 5

... Minimum LOAD/CSN Pulse High t CSW Data-to-Segment Delay t DSPD Notes: 1. See Figure 12 on page 8 for more information. 2. All limits are guaranteed. The parameters with min and max values are guaranteed with production tests or SQC (Statistical Quality Control) methods. www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 Conditions Min 100 50pF ...

Page 6

... AMB Figure 5. I vs. Temperature SEG 5V 2.4V DD OUT 5V OUT 2.7V OUT 2.7V 2.4V DD OUT -40 - (°C) AMB www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 Figure 4. Scan Frequency vs. V 980 970 960 950 940 930 920 910 900 Figure 6. I vs. V SEG 1.7V OUT 2.4V OUT 2.5 3 3.5 80 Revision 2. (V) DD ...

Page 7

... SEG SET 2.4V OUT OUT = OUT 1.7V OUT Ω SET www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 Figure 8. AS1107 Segment Output Current Intensity = 15/16 (0Fh 0.0 5.0 10.0 15.0 20.0 25.0 30.0 35.0 40.0 Figure 10. I vs. V SEG 0 Revision 2.28 Time (µs) OUT 10kΩ ...

Page 8

... At this time, all registers should be programmed for normal operation. Note: The default settings enable only scanning of one digit; the internal decoder is disabled and the Intensity Control Register (see page 12) is set to the minimum values. Figure 12. Interface Timing LOAD/CSN t CSS CLK DIN D15 DOUT www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 Table 6. Figure 12. D10 Table 7) MSB t t ...

Page 9

... Digit 2 0xX3 Digit 3 0xX4 Digit 4 0xX5 Digit 5 0xX6 Digit 6 0xX7 Digit 7 0xX8 Decode-Mode 0xX9 Intensity Control 0xXA Scan Limit 0xXB Shutdown 0xXC N/A 0xXD Feature 0xXE Display Test 0xXF 1. When Shutdown Register bit the www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 Table Address D15:D12 D11 D10 ...

Page 10

... Code-B/HEX decode for digits 7:0 Figure 13. Standard 7-Segment LED Intensity Control and Inter-Digit Blanking Table 10. Code-B Font 7-Segment Character † D7 D6: www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 HEX Code D7 D6 0x00 0 X 0x80 1 X 0x01 0 X 0x81 1 X lists some examples of the possible settings for the Decode Enable Register bits. ...

Page 11

... The devices remain in display-test mode until the Display-Test Register is set for normal operation. Note: All settings of the digit- and control-registers are maintained. Table 13. Display-Test Register Format (Address (HEX) = 0xXF)) Mode Normal Operation Display Test Mode www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 Register Data † ...

Page 12

... Display digits 0:1 (see Table 16) Display digits 0:2 (see Table 16) Display digits 0:3 Display digits 0:4 Display digits 0:5 Display digits 0:6 Display digits 0:7 Table 16. Maximum Segment Current for 1-, 2-, or 3-Digit Displays Number of Digits Displayed www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 14). HEX Code 0xX0 0xX1 0xX2 X ...

Page 13

... For example, if five devices are cascaded, in order to perform a write operation to the fifth device, the write-command must be followed by four no-operation commands. When the LOAD/CSN signal goes high, all shift registers are latched. The first four devices will receive no-operation commands and only the fifth device will receive the intended operation command, and subsequently update its register. www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 D4 D3 ...

Page 14

... SET I (mA) SEG 1.5 40 8.6kΩ 30 11.6kΩ 20 17.7kΩ 10 36.89kΩ www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 . The current that flows between V SET DD . Typical values for R for different segment currents, operating voltages, and LED SET SET Table 16 specifies the maximum currents, and R = 2.7V DD 2.0 4.4kΩ ...

Page 15

... Where +69.4°C. AMB The T limit for SO Packages in the dissipation example above is +58.6°C. AMB Table 24. Package Thermal Data Package Thermal Resistance ( 24 Narrow DIP 24 Wide SOIC www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 = 5. (V) LED 2.5 3.0 10.84kΩ 10.49kΩ 14.7kΩ 14.4kΩ 22.6kΩ ...

Page 16

... Scan-Limit Registers to display 6 digits and leave one digit unconnected. Otherwise, if one driver is set to display 6 digits and the other to display 5 digits one display will appear brighter because its duty cycle per digit will be 1/5 and the other display’s duty cycle will be 1/6. Note: Refer to No-Op Register (0xX0) on page 13 www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 8x8 LED Dot Matrix V V BAT DD 9.53kΩ ...

Page 17

... AS1106, AS1107 Datasheet - Package Drawings and Markings Figure 15. AS1106, AS1107 Marking Table 25. Packaging Code YY last two digits of the current year www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 manufacturing week plant identifier Revision 2.28 ZZ free choice / traceability code ...

Page 18

... AS1106, AS1107 Datasheet - Figure 16. SOIC 24-pin Package www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 Revision 2. ...

Page 19

... AS1106, AS1107 Datasheet - Figure 17. PDIP 24-pin Package 2. For more Information on the PDIP 24-pin package www.austriamicrosystems.com/LED-Driver-ICs/AS1106_07 see Ordering Information on page 20. Revision 2. ...

Page 20

... LED Display Drivers AS1106WE-T AS1106WE 8-Digit LED Display Drivers 1 AS1107PL 8-Digit LED Display Drivers AS1107PL AS1107WL AS1107WL 8-Digit LED Display Drivers AS1107WL-T AS1107WL 8-Digit LED Display Drivers 1. The PDIP 24-pin Package reached end of life. There is the possibility for a last time buy order until end of July 2011. ...

Page 21

... AG reserves the right to change specifications and prices at any time and without notice. Therefore, prior to designing this product into a system necessary to check with austriamicrosystems AG for current information. This product is intended for use in normal commercial applications. Applications requiring extended temperature range, unusual environmental requirements, or high reliability applications, such as military, medical life-support or life-sustaining equipment are specifically not recommended without additional processing by austriamicrosystems AG for each application ...