ATA6823-PHQW Atmel, ATA6823-PHQW Datasheet - Page 7

• Manufacturer Part Number: ATA6823-PHQW
• Description: IC H-BRIDGE MOTOR DRIVER 32-QFN
• Manufacturer: Atmel
• Type: H-Bridge Motor Driverr

Specifications of ATA6823-PHQW

• Configuration: H Bridge
• Input Type: PWM
• Delay Time: 4.25µs
• Current - Peak: 350mA
• Number Of Configurations: 1
• Number Of Outputs: 4
• Voltage - Supply: 6.5 V ~ 21.2 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 32-VQFN Exposed Pad, 32-HVQFN, 32-SQFN, 32-DHVQFN
• Operating Supply Voltage: 7 V to 18 V
• Supply Current: 7 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• High Side Voltage - Max (bootstrap): -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3.4
4856K–AUTO–01/11
5V/3.3V VCC Regulator
Figure 3-1
vated receive block of the LIN interface. After going to Active mode, the V
working.
Go to Sleep is possible with a valid HIGH to LOW transition at pin EN1 (permanent LOW for
longer than t
Switching characteristic of the outputs:
When the IC is set to SLEEP MODE by a “high to low” transition at pin EN1, the low-side tran-
sistors of the external H-bridge are switched on for a short time. This causes a shortcircuit
current pulse in the bridge because one of the high-side transistors is usually on. The pulse
length is similar to the one of the implemented short circuit detection time t
of the external FETs it needs to be considered that in the case of a short circuit condition the
current in the transistors will flow for a time t
“Electrical Characteristics” on page
short circuit behavior has to be taken into consideration, so that they will not be damaged in
the event of a short circuit condition caused by a failure or caused by the described sleep
mode switching.
Figure 3-1.
The 5V/3.3V regulator is fully integrated on-chip. It requires only a 2.2µF ceramic capacitor for
stability and has 100 mA current capability. Using the VMODE pin, the output voltage can be
selected to either 5V or 3.3V. Switching of the output voltage during operation is not intended
to be supported. The VMODE pin must be hard-wired to either VINT for 5V or to GND for 3.3V.
The logic HIGH level of the microcontroller interface will be adapted to the VCC regulator
voltage.
The output voltage accuracy is in general < ±3%; in the 5V mode with V
< 5%.
To prevent destruction of the IC, the current delivered by the regulator is limited to maximum
100mA to 350mA. The delivered voltage will break down and a reset may occur.
illustrates the wake-up by LIN. The status PREWAKE is characterized by the acti-
VCC
EN1
LIN
db
) if EN1 was in a valid HIGH state (HIGH for longer than t
Wake-up by pin LIN
Active Mode
T
gotosleep
= 20 µs
17, item 7.29. For the selection of the external FETs this
Sleep Mode
sc
T w
with a maximum of 15µs according to
akelin
= 70 µs
Regulator Wake-up Time
Atmel ATA6823
Active Mode
VBAT
db
) before.
sc
CC
< 9V it is limited to
. For the selection
regulator starts
Section 8.
7