FT245BL-REEL FTDI, Future Technology Devices International Ltd, FT245BL-REEL Datasheet - Page 9

• Manufacturer Part Number: FT245BL-REEL
• Description: IC USB TO PARALLEL
• Manufacturer: FTDI, Future Technology Devices International Ltd

Specifications of FT245BL-REEL

• Applications: USB to FIFO Controller
• Interface: USB, 8bit FIFO (Sync/Async)
• Voltage - Supply: 4.35 V ~ 5.25 V
• Package / Case: 32-LQFP
• Mounting Type: Surface Mount
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

POWER CONTROL GROUP
MISCELLANEOUS SIGNAL GROUP
Pin#
10
11
Pin#
4
5
27
28
31
DS245BL Version 1.7
Signal
PWREN#
SI / WU
Signal
RESET#
RSTOUT#
XTIN
XTOUT
TEST
Type
OUT
IN
Type
IN
OUT
IN
OUT
IN
© Future Technology Devices Intl. Ltd. 2005
Description
Goes Low after the device is configured via USB, then high during USB suspend.
Can be used to control power to external logic using a P-Channel Logic Level
MOSFET switch. Enable the Interface Pull-Down Option in EEPROM when using
the PWREN# pin in this way.
The Send Immediate / WakeUp signal combines two functions on a single pin. If
USB is in suspend mode (PWREN# = 1) and remote wakeup is enabled in the
EEPROM , strobing this pin low will cause the device to request a resume on the
USB Bus. Normally, this can be used to wake up the Host PC.
During normal operation (PWREN# = 0), if this pin is strobed low any data in the
device TX buffer will be sent out over USB on the next Bulk-IN request from the
drivers regardless of the pending packet size. This can be used to optimise USB
transfer speed for some applications. Tie this pin to VCCIO if not used.
Description
Can be used by an external device to reset the FT245BL. If not required, tie to
VCC.
Output of the internal Reset Generator. Stays high impedance for ~ 5ms after
VCC > 3.5V and the internal clock starts up, then clamps its output to the 3.3V
output of the internal regulator. Taking RESET# low will also force RSTOUT# to
drive low. RSTOUT# is NOT affected by a USB Bus Reset.
Input to 6MHz Crystal Oscillator Cell. This pin can also be driven by an external
6MHz clock if required. Note : Switching threshold of this pin is VCC/2, so if
driving from an external source, the source must be driving at 5V CMOS level or
a.c. coupled to centre around VCC/2.
Output from 6MHz Crystal Oscillator Cell. XTOUT stops oscillating during USB
suspend, so take care if using this signal to clock external logic.
Puts device in I.C. test mode – must be tied to GND for normal operation.
FT245BL USB FIFO ( USB - Parallel ) I.C.
Page 9 of 24