HCPL-2300-000E Avago Technologies US Inc., HCPL-2300-000E Datasheet - Page 11

• Manufacturer Part Number: HCPL-2300-000E
• Description: OPTOCOUPLER LO CURR 8MBD 8DIP
• Manufacturer: Avago Technologies US Inc.

Specifications of HCPL-2300-000E

• Package / Case: 8-DIP (0.300", 7.62mm)
• Voltage - Isolation: 3750Vrms
• Number Of Channels: 1, Unidirectional
• Current - Output / Channel: 25mA
• Data Rate: 8MBd
• Propagation Delay High - Low @ If: 110ns @ 500µA ~ 750µA
• Current - Dc Forward (if): 5mA
• Input Type: DC
• Output Type: Open Collector
• Mounting Type: Through Hole
• Isolation Voltage: 3750 Vrms
• Maximum Continuous Output Current: 25 mA
• Maximum Fall Time: 0.02 us
• Maximum Forward Diode Current: 5 mA
• Minimum Forward Diode Voltage: 1 V
• Output Device: Logic Gate Photo IC
• Configuration: 1 Channel
• Maximum Baud Rate: 8 MBd
• Maximum Forward Diode Voltage: 1.5 V
• Maximum Reverse Diode Voltage: 3 V
• Maximum Power Dissipation: 40 mW
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• No. Of Channels: 1
• Optocoupler Output Type: Logic Gate
• Input Current: 1mA
• Output Voltage: 5.25V
• Opto Case Style: DIP
• No. Of Pins: 8
• Common Mode Ratio: 100
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 516-1538-5

Figure 12. Recommended shunt drive circuit for interfacing between TTL/LSTTL/CMOS logic systems.
11
Figure 11. Thermal derating curve, dependence
of safety limiting value with case temperature
per IEC/EN/DIN EN 60747-5-2.
HCPL-2300/
HCPL-0300
A recommended layout for use with an internal 1000 Ω
resistor or an external pull-up resistor and required V
bypass capacitor is given in Figure 19. V
an external pull-up resistor for output voltage levels (V
greater than or equal to 5 V. As illustrated in Figure 19, an
optional V
input and the output leads of the HCPL-2300/HCPL-0300
to provide additional noise immunity at the compromise
of insulation capability (V
CC
and GND trace can be located between the
I-O
).
CC1
is used with
O
CC
)