PS2501A-1-A CEL, PS2501A-1-A Datasheet - Page 12

• Manufacturer Part Number: PS2501A-1-A
• Description: PHOTOCOUPLER 1CH TRANS OUT DIP
• Manufacturer: CEL
• Series: NEPOCr

Specifications of PS2501A-1-A

• Number Of Channels: 1
• Input Type: DC
• Voltage - Isolation: 5000Vrms
• Current Transfer Ratio (min): 50% @ 5mA
• Current Transfer Ratio (max): 400% @ 5mA
• Voltage - Output: 70V
• Current - Output / Channel: 30mA
• Current - Dc Forward (if): 30mA
• Vce Saturation (max): 300mV
• Output Type: Transistor
• Mounting Type: Through Hole
• Package / Case: 4-DIP
• Maximum Fall Time: 5 us
• Maximum Input Diode Current: 80 mA
• Maximum Reverse Diode Voltage: 6 V
• Maximum Rise Time: 3 us
• Maximum Collector Emitter Voltage: 80 V
• Maximum Collector Emitter Saturation Voltage: 0.3 V
• Isolation Voltage: 5000 Vrms
• Current Transfer Ratio: 600 %
• Maximum Forward Diode Voltage: 1.4 V
• Maximum Collector Current: 50 mA
• Maximum Power Dissipation: 150 mW
• Maximum Operating Temperature: + 100 C
• Minimum Operating Temperature: - 55 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

(4) Cautions
2. Cautions regarding noise
3. Measurement conditions of current transfer ratios (CTR), which differ according to photocoupler
USAGE CAUTIONS
10
1. Protect against static electricity when handling.
2. Avoid storage at a high temperature and high humidity.
collector-emitters at startup, the output transistor may enter the on state, even if the voltage is within the absolute
maximum ratings.
to product.
standard curves due to CTR value variations or the like. This tendency may sometimes be obvious, especially
below I
like into consideration before use.
• Fluxes
Be aware that when voltage is applied suddenly between the photocoupler’s input and output or between
Check the setting values before use, since the forward current conditions at CTR measurement differ according
When using products other than at the specified forward current, the characteristics curves may differ from the
Therefore, check the characteristics under the actual operating conditions and thoroughly take variations or the
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
F
= 1 mA.
Data Sheet PN10221EJ06V0DS
PS2501A-1,PS2501AL-1