PHOTOCOUPLER 1CH TRANS OUT 4-

PS2703-1-K-A

Manufacturer Part NumberPS2703-1-K-A
DescriptionPHOTOCOUPLER 1CH TRANS OUT 4-
ManufacturerCEL
SeriesNEPOC
PS2703-1-K-A datasheet
 

Specifications of PS2703-1-K-A

Number Of Channels1Input TypeDC
Voltage - Isolation3750VrmsCurrent Transfer Ratio (min)80% @ 1mA
Current Transfer Ratio (max)400% @ 5mAVoltage - Output120V
Current - Output / Channel30mACurrent - Dc Forward (if)50mA
Vce Saturation (max)300mVOutput TypeTransistor
Mounting TypeSurface MountPackage / Case4-SMD
Maximum Fall Time10 usMaximum Input Diode Current50 mA
Maximum Reverse Diode Voltage6 VMaximum Rise Time10 us
Maximum Collector Emitter Voltage120 VMaximum Collector Emitter Saturation Voltage0.3 V
Isolation Voltage3750 VrmsCurrent Transfer Ratio400 %
Maximum Forward Diode Voltage1.4 VMaximum Collector Current30 mA
Maximum Power Dissipation150 mWMaximum Operating Temperature+ 100 C
Minimum Operating Temperature- 55 CLead Free Status / RoHS StatusLead free / RoHS Compliant
1
Page 1
2
Page 2
3
Page 3
4
Page 4
5
Page 5
6
Page 6
7
Page 7
8
Page 8
9
Page 9
10
Page 10
11
12
13
Page 9/13

Download datasheet (295Kb)Embed
PrevNext
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
Recommended Temperature Profile of Infrared Reflow
120˚C
(2) Wave soldering
• Temperature
260°C or below (molten solder temperature)
• Time
10 seconds or less
• Preheating conditions
120°C or below (package surface temperature)
• Number of times
One (Allowed to be dipped in solder including plastic mold portion.)
• Flux
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
(3) Soldering by soldering iron
• Peak temperature (lead part temperature)
• Time (each pins)
• Flux
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100°C.
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
(heating)
to 10 s
to 60 s
180˚C
120±30 s
(preheating)
Time (s)
350°C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Data Sheet PN10242EJ02V0DS
PS2703-1
260˚C MAX.
220˚C
9