LK202-25-R-VPT Matrix Orbital, LK202-25-R-VPT Datasheet - Page 12

• Manufacturer Part Number: LK202-25-R-VPT
• Description: LCD ALPHA/NUM DISPL 20X2 BK RED
• Manufacturer: Matrix Orbital

Specifications of LK202-25-R-VPT

• Display Mode: Transmissive
• Number Of Digits/alpha: 40
• Outline L X W X H: 116.00mm x 37.00mm x 25.73mm
• Viewing Area: 82.20mm L x 18.20mm W
• Display Format: 20 x 2
• Character Size: 5.55mm H x 3.20mm W
• Character Format: 5 x 7 Dots
• Voltage - Supply: 5VDC
• Dot Size: 0.60mm W x 0.65mm H
• Interface: I²C, RS232, TTL
• Operating Temperature: 0°C ~ 50°C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Display Type: -
• Backlight: -

2.1 DB-9 Connector
standard signal levels of ±12V to ±12V. It is also possible to communicate at TTL levels of 0 to +5V by
setting the Protocol Select Jumpers to TTL. As an added feature it is also possible to apply power through
pin 9 of the DB-9 Connector in order to reduce cable clutter. However, in order to accomplish this you must
set the Power Through DB-9 Jumper.
2.1.1 Power Through DB-9 Jumper
Power through DB-9 Jumper pictured in
power through DB-9 option, see table 1 on page 10 for display module voltage requirements.
Matrix Orbital
The LK202-25 provides a DB-9 Connector to readily interface with serial devices which use the EIA232
In order to provide power through pin 9 of the DB-9 Connector you must place a solder jumper on the
1
2
3
4
DB-9 Connector
Power Through DB9 Jumper
GPOs
Manual Override
Figure 14: RS-232 Pin out
figure 15
Figure 13: LK202-25
LK202-25
below. The LK202-25 allows all voltage models to use the
Pin
Pin
Pin
Pin
5
6
7
8
Power / Data Connector
Keypad Interface
Protocol Select Jumpers
Optional Dallas 1-Wire Bridge
9
2
3
5
Tx \ SDA (I
Rx \ SCL (I
GND
PWR
9 Jumper. See table 1 on page 10 for
power requirements.)
(Must solder Power Through DB-
2
2
C clock)
C data)
8