T-55465D065J-LW-A-AAN Optrex America Inc, T-55465D065J-LW-A-AAN Datasheet - Page 22

• Manufacturer Part Number: T-55465D065J-LW-A-AAN
• Description: LCD 6.5" TFT MOD 640X480 VGA
• Manufacturer: Optrex America Inc

Specifications of T-55465D065J-LW-A-AAN

• Display Type: TFT- Thin Film Transistor
• Display Mode: Transmissive
• Viewing Area: 132.50mm L x 99.40mm W
• Backlight: LED - White
• Dot Size: *
• Dot Pitch: *
• Dot Pixels: 640 x 480 (VGA)
• Interface: CMOS
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

(3) PRECAUTIONS WITH ELECTROSTATICS
(4) STORAGE PRECAUTIONS
(5) SAFETY PRECAUTIONS
OPTREX Confidential
(2) OPERATING PRECAUTIONS
i. Please handle metal frame carefully because edge of metal frame is very sharp.
j. Please pay attention to handling LED backlight cable so that it is not tugged in connecting with
k. Please connect the metal frame of LCD module to GND in order to minimize the effect of
l. Be sure to connect the cables and the connecters correctly.
a. Please be sure to turn off the power supply before connecting and disconnecting signal input
b. Please do not change variable resistance settings in LCD module. They are adjusted to the most
c. The interface signal speed is very high. Please pay attention to transmission line design and
d. A condensation might happen on the surface and inside of LCD module in case of sudden change
e. Please pay attention not to display the same pattern for very long time. Image might stick on
f. Please obey the same safe instructions as ones being prepared for ordinary electronic products.
a. This LCD module use CMOS-IC on circuit board and TFT-LCD panel, and so it is easy to be
b. Please remove protection film very slowly from the surface of LCD module to prevent from
a. Please do not leave the LCDs in the environment of high humidity and high temperature such as
b. Please do not leave the LCDs in the environment of low temperature; below –30°C.
a. When you waste damaged or unnecessary LCDs, it is recommended to crush LCDs into pieces
60°C90%RH.
cable.
affected by electrostatics. Please be careful with electrostatics by the way of your body
connecting to the ground and so on.
frames can happen during a long preservation of soiled LCD modules.
LED driver.
external noise and EMI.
suitable value. If they are changed, it might happen LCD does not satisfy the characteristics
specification.
other high speed signal precautions to satisfy signal specification.
of ambient temperature.
LCD. Even if image sticking happens, it may disappear as the operation time proceeds.
electrostatics occurrence.
(22/23)
T-55465GD065J-LW-A-AAN