T-51431L016J-FW-P-AA Optrex America Inc, T-51431L016J-FW-P-AA Datasheet - Page 21

• Manufacturer Part Number: T-51431L016J-FW-P-AA
• Description: LCD 1.6" TFT MOD MTSC/PAL
• Manufacturer: Optrex America Inc

Specifications of T-51431L016J-FW-P-AA

• Display Type: TFT- Thin Film Transistor
• Display Mode: *
• Viewing Area: 32.40mm L x 24.30mm W
• Dot Pitch: 0.14mm x 0.10mm
• Dot Pixels: 240 x 234
• Interface: -
• Backlight: -
• Dot Size: -
• Other names: 73-1212

11. Handling Cautions
handled carefully.
11-1) Mounting of module
11-2) Precautions in mounting
11-3) Others
d)
c) Polarizer which is made of soft material and susceptible to flaw must be
a) Please power off the module when you connect the input/output connector.
b) Please connect the ground pattern of the inverter circuit surely. If the
a) When metal part of the TFT-LCD module (shielding lid and rear case) is
b) Wipe off water drops or finger grease immediately. Long contact with water
c) TFT-LCD module uses glass which breaks or cracks easily if dropped or
d) Since CMOS LSI is used in the module. So take care of static electricity
a) Do not expose the module to direct sunlight or intensive ultraviolet rays for
b) Store the module at a room temperature place.
a) The voltage of beginning electric discharge may over the normal voltage
b) If LCD panel breaks, it is possibly that the liquid crystal escapes from the
c) Observe all other precautionary requirements in handling general electronic
d) Please adjust the voltage of common electrode as material of attachment
1.The noise from the backlight unit will increase.
2.The output from inverter circuit will be unstable.
3.In some cases a part of module will heat.
scratches and dirt. It is recommended to peel off the laminator before use
and taking care of static electricity.
Protective film (Laminator) is applied on surface to protect it against
T-51431L016J-FW-P-AA
soiled, wipe it with soft dry cloth.
may cause discoloration or spots.
bumped on hard surface. Please handle with care.
many Hours.
because of leakage current from approach conductor by to draw lump read
lead line around.
panel.
Avoid putting it into eyes or mouth. When liquid crystal sticks on hands,
clothes or feet. Wash it out immediately with soap.
components.
by 1 module.
connection is not perfect, some following problems may happen possibly.
and earth yourself when handling.
OPTREX CORPORATION
Page 21/23