PVC6H105A01B00 Murata Electronics North America, PVC6H105A01B00 Datasheet - Page 7

• Manufacturer Part Number: PVC6H105A01B00
• Description: POT 1M OHM TRIM 1TRN SIDE
• Manufacturer: Murata Electronics North America
• Series: PVC6r

Specifications of PVC6H105A01B00

• Resistance (ohms): 1M
• Power (watts): 0.5W, 1/2W
• Taper: Linear
• Tolerance: ±10%
• Temperature Coefficient: ±100ppm/°C
• Number Of Turns: Single
• Adjustment Type: Side Adjustment
• Mounting Type: Through Hole
• Resistive Material: Ceramic
• Package / Case: Square - 0.272" L x 0.256" W x 0.315" H (6.90mm x 6.50mm x 8.00mm)
• Resistance In Ohms: 1.00M
• Lead Free Status / RoHS Status: Lead free / RoHS non-compliant
• Other names: 490-2142

!Note
!Note
1. Use suitable screwdrivers that fit comfortably in
1. Please make sure that your product has been
2. Murata cannot guarantee trimmer potentiometer
Notice (Handling)
driver slot. We recommend the screwdrivers below.
* Recommended screwdriver for manual adjustment
* Recommended screwdriver bit for automatic
We can supply the screwdrivers avobe.
Notice (Other)
evaluated and confirmed against your
specifications when our product is mounted to your
product.
integrity when used under conditions other than
those specified in this document.
<PVC6 series>
<PV32/34 series>
adjustment
<PVC6 series>
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specifications before ordering.
VESSEL MFG. : NO.9000+0x30
TORAY INDUSTRIES, INC. : SA-2225
ENGINEER INC. : DA-40
VESSEL MFG. : NO.CA-10
TORAY INDUSTRIES, INC. : JB-2225
(Murata P/N : KMDR150)
(Murata P/N : KMDR070)
(Murata P/N : KMDR180)
(Murata P/N : KMBT090)
(Murata P/N : KMBT070)
2. Don't apply more than 9.8N (Ref.; 1kgf) of twist
3. When adjusting with an adjustment tool, the applied
4. The rotational torque at the position of the
5. When using a lock paint to fix slot position,
If you place an order, please specify the
Murata P/N.
and stress after mounting onto PCB to prevent
contact intermittence. If excessive force is
applied, the trimmer potentiometer may not
function.
force to the adjustment screw should not exceed
4.9N (Ref.; 500gf). If excessive force is applied,
the trimmer potentiometer may not function due to
damage.
adjustment range should not exceed the stop
strength.
please use adhesive resin without chlorine or
sulfur (Three-bond "1401 series").
PVC6/PV32/PV34 Series Notice
R50E13.pdf 04.6.11
53
7