Q48SK12025NRFH Delta Electronics, Q48SK12025NRFH Datasheet - Page 9

• Manufacturer Part Number: Q48SK12025NRFH
• Description: CONV DC/DC 25A 48V/IN 12V/O NEG
• Manufacturer: Delta Electronics
• Series: DELPHIr
• Type: Isolated with Remote On/Off and UVLOr

Specifications of Q48SK12025NRFH

• Output: 12V
• Number Of Outputs: 1
• Power (watts): 300W
• Mounting Type: Through Hole
• Voltage - Input: 48V
• Package / Case: 6-DIP Module, 1/4 Brick
• 1st Output: 12 VDC @ 25A
• Size / Dimension: 2.28" L x 1.45" W x 0.50" H (57.9mm x 36.8mm x 12.7mm)
• Power (watts) - Rated: 300W
• Operating Temperature: -40°C ~ 112°C
• Efficiency: 95.2%
• Approvals: cUL, UL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• 4th Output: -
• Other names: 941-1012

DS_Q48SK12025_07012010
THERMAL CONSIDERATIONS
Thermal management is an important part of the system
design. To ensure proper, reliable operation, sufficient
cooling of the power module is needed over the entire
temperature range of the module. Convection cooling is
usually the dominant mode of heat transfer.
Hence, the choice of equipment to characterize the
thermal performance of the power module is a wind
tunnel.
Thermal Testing Setup
Delta’s DC/DC power modules are characterized in
heated vertical wind tunnels that simulate the thermal
environments
equipment. This type of equipment commonly uses
vertically mounted circuit cards in cabinet racks in which
the power modules are mounted.
The
characterization setup. The power module is mounted
on a test PWB and is vertically positioned within the
wind tunnel. The space between the neighboring PWB
and the top of the power module is constantly kept at
6.35mm (0.25’’).
Figure 17: Wind tunnel test setup
Thermal Derating
Heat can be removed by increasing airflow over the
module. To enhance system reliability, the power
module should always be operated below the maximum
operating temperature. If the temperature exceeds the
maximum module temperature, reliability of the unit may
be affected.
Note: Wind Tunnel Test Setup Figure Dimensions are in millimeters and (Inches)
MEASURED BELOW
following
TEMPERATURE
AIR VELOCITY
AND AMBIENT
THE MODULE
FACING PWB
encountered
figure
AIR FLOW
shows
in
PWB
50.8 (2.0”)
MODULE
12.7 (0.5”)
the
most
wind
electronics
tunnel
9