MPDTY022S Murata Electronics North America, MPDTY022S Datasheet - Page 7

• Manufacturer Part Number: MPDTY022S
• Description: CONV DC/DC 7.2W 1.2VOUT 6A SIP
• Manufacturer: Murata Electronics North America
• Series: MPDr
• Type: Point of Load (POL) Non-Isolated with UVLOr

Specifications of MPDTY022S

• Output: 1.2V
• Number Of Outputs: 1
• Power (watts): 7W
• Mounting Type: Through Hole
• Voltage - Input: 4 ~ 5.5V
• Package / Case: 12-SIP Module
• 1st Output: 1.2 VDC @ 6A
• Size / Dimension: 1.30" L x 0.23" W x 0.94" H (33mm x 5.8mm x 24mm)
• Power (watts) - Rated: 7.2W
• Operating Temperature: -40°C ~ 85°C
• Efficiency: 93%
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• Other names: 490-4552

1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
Note:
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
specifications or transact the approval sheet for product specifications before ordering.
9.2. Operation Information
9.2.1. Reset Condition
9.2.2. Over Voltage Protection (OVP)
9.2.3. Low Voltage Protection (LVP)
In order to reset all function , the input voltage (Vin) is set under 5V for 1s. min.
The Isolated DC-DC Converter become into latch-up mode after typical 0.5ms. mask time,when the
output voltage is over the value specified in Over Voltage Protection(9.1.2) by failure of internal control
circuit. In order to reset, the input voltage is set under 5V for 1s. min. Output voltage might exceed the
point at which OVP starts to function under the specific condition of transient input voltage or output
current change. Therefore,OVP is set to wait for the mask time 0.5ms. It is recommended to evaluate
your appliances installed with the DC-DC Converter.
The Isolated DC-DC Converter becomes into latch-up mode after typical 500ms. mask time,when the
output voltage is under the value specified in Low Voltage
Protection(9.1.2) by operating Over Current-limit Inception due to failure of internal control or over load.
In order to reset, the input voltage is set under 5V for 1s. min.
Reset Condition
Reset Condition
Reset Condition
Vin 36 to 75V
Vin 36 to 75V
Vin 36 to 75V
5V min
5V min
5V min
1s.min
1s.min
1s.min
MPD6D12*S Specification
2010.5.7
7