AC162058 Microchip Technology, AC162058 Datasheet - Page 4

• Manufacturer Part Number: AC162058
• Description: HEADER MPLAB ICD2 FOR PIC12F683
• Manufacturer: Microchip Technology
• Series: PIC12r

Specifications of AC162058

• Accessory Type: Transition Header
• Mcu Supported Families: PIC12
• Convert To: PIC12F683-ICD
• Convert From: 8-pin PIC12F683
• Supported Devices: PIC12F683
• For Use With: AC164110 - ADAPTER RJ-11 TO ICSP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ICD2, PIC12F683
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

MPLAB
DS51292L-page 4
®
ICD 2
18-PIN HEADERS
For these headers, there are no jumpers/switches. The device with the most program
memory is always selected.
If PIC16F627A or PIC16F628A devices are selected for MPLAB ICD 2 development in
MPLAB IDE, the warning “ICDWarn0020: Invalid target device id” may be received in
the build window and as a dialog. The reason is the PIC16F648A-ICD device supports
PIC16F648A, PIC16F627A and PIC16F628A, but only reports the device ID for the
PIC16F648A.
Ignore this warning or disable it under the Warnings tab on the ICD Programming
dialog.
20-PIN HEADER – PIC16F639
For the PIC16F639 20-pin header, you will need to connect the jumper J3 as specified
below.
In addition to being used with MPLAB ICD 2, this header is used with the PCM16YM0
processor module to emulate a PIC16F639 on the MPLAB ICE 2000 in-circuit emulator.
Plug the end of the processor module into the header, and then plug the header into
the transition socket or directly onto the target board.
20-PIN HEADER – PIC16F785
For the PIC16F785 20-pin header, you will need to connect the jumper J2 to enable the
shunt regulator.
20-PIN HEADER – PIC16F690
For the PIC16F690 20-pin header, you will need to set the S1 switches (Figure 2) to
enable peripherals and choose devices (Table 3).
FIGURE 2:
MPLAB
MPLAB ICD 2
PIC16F785
PIC16HV785
Device
®
Tool
ICE 2000
ON
Jumper Setting
S1 SWITCH HARDWARE
ENABLE
Jumper Setting
ADC
4kPFM
USART
SSP
ECCP
1-2
2-3
1-2
2-3
Disable shunt regulator
Switch configuration at left shows all
peripherals enabled, which is the setting to
select the PIC16F690 device.
Enable shunt regulator
Run/program as regular device
Run/program as ICD device
Function
© 2005 Microchip Technology Inc.
Function