XE8000EV110 Semtech, XE8000EV110 Datasheet - Page 5

• Manufacturer Part Number: XE8000EV110
• Description: EVAL BOARD FOR XE8802AMI035LF
• Manufacturer: Semtech
• Type: MCUr

Specifications of XE8000EV110

• Contents: Fully Assembled Evaluation Board
• For Use With/related Products: XE88LC02MI035
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.6 Installing XE8000EV110 hardware
2.6.1
The XE8802 must be placed with the pin 1 marker aligned with the pin 1 marker of the board. See picture below:
Figure 1 Position of the chip in the ZIF socket
2.6.2
To use an external power supply, the user must connect the pins labelled “+” and “-“ (see Figure 2) on the header
named “EXT POWER” near the battery carrier with regulated 1.2 to 5.5 Volts power supply. The switch must be in the
“on” position.
Warning this power source is not protected by a fuse!
the current of the power supply source.
2.6.3
To power the application with a battery, you may place a button battery of the type cr1620 on the carrier (+ on the top,
diameter 16mm height 2.0mm). Since the carrier is flexible, the height can vary a little bit.
Warning this power source is not protected by a fuse!
2.6.4
Please refer to ProStart II user guide to use the XE8000EV110 with the ProStart II as a power supply or a programmer.
Note : When the ProStart II (XE8000MP) is connected, all the other supply sources are bypassed, the default supply of
the ProStart II (XE8000MP) is 3.0 Volts and the programming voltage is 5.0 Volts.
2.6.5
To use an external clock source, the user must disconnect the on onboard xtal by removing the br1 jumper, and place
it’s own source on the pin XIN on the header. (see Figure 3)
2.6.6
To measure the consumption of the XE8802, the user must remove the jumper named br_consumption and place an
amperemeter between these two points.
2.6.7
To use the on board EEPROM, place the jumpers br4 to br7, and for the software please check on our web site for the
technical note TN8000.14 on
© Semtech 2006
Placing the chip on the ZIF socket
Using an external power supply
Using a button type battery
Using the ProStart II as power supply and programmer
Using an external clock source
Measuring the circuit consumption
How to use the on-board EEPROM
http://www.semtech.com
5
Pin 1 marker
The user can prevent destroying the board/chip by limiting
XE8000EV110
User Guide
www.semtech.com