AD9852/PCB Analog Devices Inc, AD9852/PCB Datasheet - Page 24

• Manufacturer Part Number: AD9852/PCB
• Description: BOARD EVAL FOR AD9852
• Manufacturer: Analog Devices Inc

Specifications of AD9852/PCB

• Rohs Status: RoHS non-compliant
• Module/board Type: Evaluation Board
• For Use With/related Products: AD9852
• Lead Free Status / Rohs Status: Not Compliant

AD9852
supplied or internally generated. See the Internal and External
Update Clock section for a discussion of the I/O update.
Alternatively, the CLR ACC2 control bit (Register Address 1F hex)
is available to clear both the frequency accumulator (ACC1)
and the phase accumulator (ACC2). When this bit is set high,
the output of the phase accumulator results in 0 Hz output from
the DDS. As long as this bit is set high, the frequency and phase
accumulators are cleared, resulting in 0 Hz output. To return to
the previous DDS operation, CLR ACC2 must be set to logic
low. This bit is useful for generating pulsed FM.
Figure 43 graphically illustrates the effect of the CLR ACC2 bit on
the DDS output frequency. Reprogramming the registers while
the CLR ACC2 bit is high allows a new FTW1 frequency and
slope to be loaded.
RAMP RATE
I/O UD CLK
CLR ACC1
MODE
FTW1
DFW
FREQUENCY
000 (DEFAULT)
F1
0
0
Figure 42. Effect of CLR ACC1 in FM Chirp Mode
Rev. E | Page 24 of 52
DELTA FREQUENCY WORD
RAMP RATE
011 (CHIRP)
Another function only available in the chirp mode is the
HOLD pin (Pin 29). This function stops the clock signal to the
ramp rate counter, thereby halting any further clocking pulses
to the frequency accumulator, ACC1.
The effect is to halt the chirp at the frequency existing just
before the HOLD pin is pulled high. When the HOLD pin is
returned low, the clock resumes and chirp continues. During a
hold condition, the user can change the programming registers;
however, the ramp rate counter must resume operation at its
previous rate until a count of 0 is obtained before a new ramp
rate count can be loaded. Figure 44 illustrates the effect of the
hold function on the DDS output frequency.
F1