G6E-134P-ST-US-DC3 Omron, G6E-134P-ST-US-DC3 Datasheet - Page 6

• Manufacturer Part Number: G6E-134P-ST-US-DC3
• Description: RELAY SPDT PCB 2A 3VDC
• Manufacturer: Omron
• Series: G6Er

Specifications of G6E-134P-ST-US-DC3

• Coil Type: Standard
• Coil Current: 66.7mA
• Relay Type: General Purpose
• Circuit: SPDT (1 Form C)
• Contact Rating @ Voltage: 2A @ 30VDC
• Coil Voltage: 3VDC
• Control On Voltage (max): 2.1 VDC
• Control Off Voltage (min): 0.3 VDC
• Mounting Type: Through Hole
• Termination Style: PC Pin
• Contact Configuration: SPDT
• Contact Current Max: 3A
• Contact Voltage Ac Nom: 125V
• Contact Voltage Dc Nom: 30V
• Coil Voltage Vdc Nom: 3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: G6E-134P-ST-USDC3; G6E-134P-ST-USDC3; G6E134PSTUSDC3; Z2599

Precautions
■ Precautions for Correct Use
Long-term Continuously ON Contacts
Using the Relay in a circuit where the Relay will be ON continuously
for long periods (without switching) can lead to unstable contacts
because the heat generated by the coil itself will affect the insulation,
causing a film to develop on the contact surfaces. We recommend
using a latching relay (magnetic-holding relay) in this kind of circuit. If
a single-side stable model must be used in this kind of circuit, we rec-
ommend using a fail-safe circuit design that provides protection
against contact failure or coil burnout.
Installation
Do not reverse the polarity of the coil (+, -).
Provide sufficient space between Relays when mounting two or more
on the same PCB, as shown in the following diagram.
■ Hints on Correct Use
Single-winding type (G6EU)
Example of low-power consumption driver circuit
1. This is an example of a driver circuit that allows Model G6E to
2. The relay is set by an abrupt current charged to capacity C. This
3. The relay is reset by the discharge current of C flowing in the relay
Note: 1. Give adequate consideration to the circuit constant when
94
function as a normal relay with a normal switching pulse input.
current flows in the relay via diode D
via transistor TR and C.
2. OMRON owns the patent on this circuit. Consult OMRON
actually using this circuit, confirming the set and reset status
of the relay.
when using this circuit.
Low Signal Relay
Close
mounting
Distance between terminals:
2.54 × 2 (pitch) max.
G6E
1
and C and out via diode D
2
.
Wiring
Refer to the following diagram when wiring to switch a DC load. The
difference in polarity applied to the contacts will affect the endurance
of the Relay due to the amount of contact movement. To extend the
endurance characteristics beyond the performance ratings, wire the
common (pin 7) terminal to the positive (+) side.
Ultrasonic Cleaning
Do not use ultrasonic cleaning on standard relay models. Doing so
may result in resonance, coil burnout, and contact adhesion within
the Relay.
Relay Handling
When washing the product after soldering the Relay to a PCB, use a
water-based solvent or alcohol-based solvent, and keep the solvent
temperature to less than 40°C. Do not put the Relay in a cold clean-
ing bath immediately after soldering.
+
−
Wiring Diagram
Load
12
7
10
Load