PIC24HJ32GP302-I/SO Microchip Technology, PIC24HJ32GP302-I/SO Datasheet - Page 124

• Manufacturer Part Number: PIC24HJ32GP302-I/SO
• Description: IC PIC MCU FLASH 32K 28SOIC
• Manufacturer: Microchip Technology
• Series: PIC® 24Hr

Specifications of PIC24HJ32GP302-I/SO

• Core Size: 16-Bit
• Program Memory Size: 32KB (11K x 24)
• Core Processor: PIC
• Speed: 40 MIPs
• Connectivity: I²C, PMP, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, DMA, POR, PWM, WDT
• Number Of I /o: 21
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b/12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 28-SOIC (7.5mm Width)
• Controller Family/series: PIC24
• No. Of I/o's: 21
• Ram Memory Size: 4KB
• Cpu Speed: 40MIPS
• No. Of Timers: 7
• No. Of Pwm Channels: 4
• Embedded Interface Type: I2C, SPI, UART
• Rohs Compliant: Yes
• Processor Series: PIC24HJ
• Core: PIC
• Data Bus Width: 16 bit
• Data Ram Size: 4 KB
• Interface Type: I2C, SPI, UART
• Maximum Clock Frequency: 40 MHz
• Number Of Programmable I/os: 21
• Number Of Timers: 5
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: 52713-733, 52714-737, 53276-922, EWDSPIC
• Development Tools By Supplier: PG164130, DV164035, DV244005, DV164005, PG164120, DM300027
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 10 Channel / 12 bit, 10 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: AC164339 - MODULE SKT FOR PM3 28SOIC
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

REGISTER 9-1:
DS70293D-page 124
bit 2
bit 1
bit 0
Note 1: Writes to this register require an unlock sequence. Refer to Section 39. “Oscillator (Part III)” (DS70308)
2: Direct clock switches between any primary oscillator mode with PLL and FRCPLL mode are not permitted.
in the “dsPIC33F Family Reference Manual” (available from the Microchip website) for details.
This applies to clock switches in either direction. In these instances, the application must switch to FRC mode
as a transition clock source between the two PLL modes.
Unimplemented: Read as ‘0’
LPOSCEN: Secondary (LP) Oscillator Enable bit
1 = Enable secondary oscillator
0 = Disable secondary oscillator
OSWEN: Oscillator Switch Enable bit
1 = Request oscillator switch to selection specified by NOSC<2:0> bits
0 = Oscillator switch is complete
OSCCON: OSCILLATOR CONTROL REGISTER
Preliminary
(1)
(CONTINUED)
© 2009 Microchip Technology Inc.