PIC18F8520-I/PT Microchip Technology, PIC18F8520-I/PT Datasheet
PIC18F8520-I/PT
Specifications of PIC18F8520-I/PT
Available stocks
Related parts for PIC18F8520-I/PT
PIC18F8520-I/PT Summary of contents
Page 1
... PIC18F6520/8520 devices with these Device/ Revision IDs: Part Number Device ID PIC18F6520 00 1011 001 PIC18F8520 00 1011 000 The Device IDs (DEVID1 and DEVID2) are located at addresses 3FFFFEh:3FFFFFh in configuration space. They are shown in hexadecimal in the format “DEVID2 DEVID1”. 1. Module: I/O Ports (Parallel Slave Port) While operating in Parallel Slave Port mode, the OBF bit (PSPCON< ...
Page 2
... Asynchronous mode. Work around Load the first character into TXREGx and then wait for a TXx interrupt, or check the TXxIF bit before writing each additional character to TXREGx. Date Codes that pertain to this issue: All engineering and production devices. 2005 Microchip Technology Inc. ...
Page 3
... Shaded cells are unimplemented, read as ‘0’. Note 1: Unimplemented in PIC18F6X20 devices, read as ‘0’. 2: Unimplemented in PIC18FX520 and PIC18FX620 devices, read as ‘0’. 3: Unimplemented in PIC18FX620 and PIC18FX720 devices, read as ‘0’. 4: See Register 23-13 for DEVID1 values. 2005 Microchip Technology Inc. PIC18F6520/8520 Bit 5 Bit 4 Bit 3 ...
Page 4
... Standard Operating Conditions (unless otherwise stated) PIC18FXX20 Operating temperature (Industrial, Extended) Param Device No. D025 Timer1 Oscillator (∆I ) PIC18F8520/8620 OSCB PIC18LF6520/8520 D026 A/D Converter (∆ Legend: Shading of rows is to assist in readability of the table. Note 1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to V current disabled (such as WDT, Timer1 Oscillator, BOR, etc ...
Page 5
... Retention time is valid, provided no other specifications are violated. 4: Refer to Section 7.8 “Using the Data EEPROM” for a more detailed discussion on data EEPROM endurance. 2005 Microchip Technology Inc. PIC18F6520/8520 Standard Operating Conditions (unless otherwise stated) -40°C ≤ T ≤ +85°C for industrial ...
Page 6
... T0PS2, T0PS1, T0PS0 1 Sync with Internal TMR0L Clocks Delay PSA Data Bus 8 TMR0 Set Interrupt Flag bit TMR0IF on Overflow Set Interrupt TMR0 Flag bit TMR0IF High Byte on Overflow 8 Read TMR0L Write TMR0L 8 8 TMR0H 8 Data Bus<7:0> 2005 Microchip Technology Inc. ...
Page 7
... Legend: Shading of rows is to assist in readability of the table. Note 1: This is the limit to which V can be lowered in Sleep mode, or during a device Reset, without losing RAM data. DD 2005 Microchip Technology Inc. PIC18F6520/8520 D001) “DC Standard Operating Conditions (unless otherwise stated) -40°C ≤ T ≤ +85°C for industrial ...
Page 8
... Parameter is characterized but not tested. DS80157D-page 8 Standard Operating Conditions (unless otherwise stated) Operating temperature -40°C ≤ T Min (1) 0 1.6 ≤ +85°C for industrial A -40°C ≤ T ≤ +125°C for extended A Max Units Conditions 2005 Microchip Technology Inc. ...
Page 9
... PIC18F6520/8520 VOLTAGE-FREQUENCY GRAPH (INDUSTRIAL, EXTENDED) 6.0V 5.5V 5.0V 4.5V 4.0V 3.5V 3.0V 2.5V 2. MHz for PIC18F6520/8520 in Microcontroller mode. MAX MHz for PIC18F6520/8520 in modes other than Microcontroller mode. MAX F (Extended MHz. MAX 2005 Microchip Technology Inc. PIC18F6520/8520 PIC18FX520 F (Extended) F MAX MAX Frequency 4.2V DS80157D-page 9 ...
Page 10
... XT oscillator 40 250 ns HS oscillator (Industrial) 62.5 250 ns HS oscillator (Extended) 100 250 ns HS+PLL, PIC18FX520 (Industrial) 160 250 ns HS+PLL, PIC18FX520 using external memory interface (Industrial) 160 250 ns HS+PLL, PIC18FX520 (Extended) µs 30 200 LP Oscillator mode 2005 Microchip Technology Inc. Conditions ...
Page 11
... Param Sym Characteristics No. D311 V Absolute Accuracy RAA 2005 Microchip Technology Inc. PIC18F6520/8520 11. Module: OSCCON Register In the OSCCON register (Register 2-1, page 25), the Reset value for the SCS bit (OSCCON<0>) was incorrectly stated as R/W-1 and has been changed to R/W-0 , should be RAA < ...
Page 12
... REF DD LSb 5.0V REF DD LSb 5.0V REF DD ≤ V ≤ V — AIN REF V V < 3.0V DD ≥ 3. ≥ 2.5V (Note kΩ (Note 4) µA Average current during conversion µA µA During V acquisition. AIN µA During A/D conversion cycle. 2005 Microchip Technology Inc. ...
Page 13
... Characteristics Specifications. Added Data Sheet Clarification issues 7 (Voltage-Frequency Graph), 8 (External Clock Timing Requirements), 9 (CCP), Reference Specifications), 11 (OSCCON Register), 12 (Instruction Set – BTG) and 13 (A/D Converter Characteristics). 2005 Microchip Technology Inc. PIC18F6520/8520 Programming Specifications) Data Sheet 26-4: Memory (Timer0 Block – ...
Page 14
... PIC18F6520/8520 NOTES: DS80157D-page 14 2005 Microchip Technology Inc. ...
Page 15
... PowerCal, PowerInfo, PowerMate, PowerTool, rfLAB, rfPICDEM, Select Mode, Smart Serial, SmartTel and Total Endurance are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies. ...
Page 16
... Fax: 65-6334-8850 Taiwan - Kaohsiung Tel: 886-7-536-4818 Fax: 886-7-536-4803 Taiwan - Taipei Tel: 886-2-2500-6610 Fax: 886-2-2508-0102 Taiwan - Hsinchu Tel: 886-3-572-9526 Fax: 886-3-572-6459 2005 Microchip Technology Inc. EUROPE Austria - Weis Tel: 43-7242-2244-399 Fax: 43-7242-2244-393 Denmark - Ballerup Tel: 45-4450-2828 Fax: 45-4485-2829 France - Massy Tel: 33-1-69-53-63-20 ...