DSPIC30F4013T-20E/ML Microchip Technology, DSPIC30F4013T-20E/ML Datasheet - Page 4

• Manufacturer Part Number: DSPIC30F4013T-20E/ML
• Description: IC DSPIC MCU/DSP 48K 44QFN
• Manufacturer: Microchip Technology
• Series: dsPIC™ 30Fr

Specifications of DSPIC30F4013T-20E/ML

• Core Processor: dsPIC
• Core Size: 16-Bit
• Speed: 20 MIPS
• Connectivity: CAN, I²C, SPI, UART/USART
• Peripherals: AC'97, Brown-out Detect/Reset, I²S, POR, PWM, WDT
• Number Of I /o: 30
• Program Memory Size: 48KB (16K x 24)
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 5.5 V
• Data Converters: A/D 13x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 44-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

dsPIC30F3014/4013
Silicon Errata Issues
1. Module: CPU
DS80455D-page 4
Note:
Sequential MAC class instructions, which prefetch
data from Y data space using ±4 address
modification, will cause an address error trap. The
trap occurs only when all the following conditions
are true:
1. Two sequential MAC class instructions (or a
2. Both instructions prefetch data from Y data
3. Neither of the instruction uses an accumulator
Work around
The problem described above can be avoided by
using any of the following methods:
1. Inserting any other instruction between the two
2. Adding an accumulator write back (a dummy
3. Do not use the + = 4 or - = 4 address
4. Do not prefetch data from Y data space.
Affected Silicon Revisions
A1
X
MAC class instruction executed in a REPEAT or
DO loop) that prefetch from Y data space.
space using the + = 4 or - = 4 address
modification.
write back.
MAC class instructions.
write back if needed) to either of the MAC class
instructions.
modification.
This document summarizes all silicon
errata issues from all revisions of silicon,
previous as well as current. Only the
issues indicated by the shaded column in
the following tables apply to the current
silicon revision (A2).
A2
X
2. Module: CPU
EXAMPLE 1:
L0:DAW.b
L1: ....
The Decimal Adjust instruction, DAW.b, may
improperly clear the Carry bit, C (SR<0>), when
executed.
Work around
Check the state of the Carry bit prior to executing
the DAW.b instruction. If the Carry bit is set, set the
Carry bit again after executing the DAW.b
instruction. Example 1 shows how the application
should process the Carry bit during a BCD addition
operation.
Affected Silicon Revisions
.include “p30f5013.inc”
.......
MOV.b
MOV.b
ADD.b
BRA
DAW.b
BSET.b
BRA
A1
X
A2
X
#0x80, w0
#0x80, w1
w0, w1, w2 ;Perform addition
NC, L0
w2
L1
w2
SR, #C
CHECK CARRY BIT BEFORE
DAW.b
© 2010 Microchip Technology Inc.
;First BCD number
;Second BCD number
;If C set go to L0
;If not,do DAW and
;set the carry bit
;and exit