C8051T612-GQ Silicon Laboratories Inc, C8051T612-GQ Datasheet - Page 56

• Manufacturer Part Number: C8051T612-GQ
• Description: IC 8051 MCU 8K BYTE-PROG 32-LQFP
• Manufacturer: Silicon Laboratories Inc
• Series: C8051T61xr

Specifications of C8051T612-GQ

• Program Memory Type: OTP
• Program Memory Size: 8KB (8K x 8)
• Package / Case: 32-LQFP
• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 25MHz
• Connectivity: SMBus (2-Wire/I²C), SPI, UART/USART
• Peripherals: POR, PWM, Temp Sensor, WDT
• Number Of I /o: 29
• Ram Size: 1.25K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 3.6 V
• Data Converters: A/D 21x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Processor Series: C8051T6x
• Core: 8051
• Data Bus Width: 8 bit
• Data Ram Size: 1.25 KB
• Interface Type: I2C/SPI/UART
• Maximum Clock Frequency: 25 MHz
• Number Of Programmable I/os: 29
• Number Of Timers: 4
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: PK51, CA51, A51, ULINK2
• Development Tools By Supplier: C8051FT610DK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 21-ch x 10-bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1439

C8051T610/1/2/3/4/5/6/7
11. Voltage Regulator (REG0)
C8051T610/1/2/3/4/5/6/7 devices include an internal voltage regulator (REG0) to regulate the internal core
supply to 1.8 V from a V
supply of 1.8 to 3.6 V. Two power-saving modes are built into the regulator to
DD
help reduce current consumption in low-power applications. These modes are accessed through the
REG0CN register (SFR Definition 11.1). Electrical characteristics for the on-chip regulator are specified in
Table 7.5 on page 34
If an external regulator is used to power the device, the internal regulator may be put into bypass mode
using the BYPASS bit. The internal regulator should never be placed in bypass mode unless an
external 1.8 V regulator is used to supply V
. Doing so could cause permanent damage to the
DD
device.
Under default conditions, when the device enters STOP mode the internal regulator will remain on. This
allows any enabled reset source to generate a reset for the device and bring the device out of STOP mode.
For additional power savings, the STOPCF bit can be used to shut down the regulator and the internal
power network of the device when the part enters STOP mode. When STOPCF is set to 1, the RST pin or
a full power cycle of the device are the only methods of generating a reset.
56
Rev 1.0