DF2367VTE33 Renesas Electronics America, DF2367VTE33 Datasheet - Page 344

• Manufacturer Part Number: DF2367VTE33
• Description: IC H8S MCU FLASH 384K 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2367VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2367VTE33; HD64F2367VTE33

Section 7 DMA Controller (DMAC)
When the DMAC accesses internal space (on-chip memory or an internal I/O register), the DMAC
cycle may be executed at the same time as a refresh cycle or external bus release cycle.
7.5.14
When an NMI interrupt is requested, burst mode transfer in full address mode is interrupted. An
NMI interrupt does not affect the operation of the DMAC in other modes.
In full address mode, transfer is enabled for a channel when both the DTE bit and DTME bit are
set to 1. With burst mode setting, the DTME bit is cleared when an NMI interrupt is requested.
If the DTME bit is cleared during burst mode transfer, the DMAC discontinues transfer on
completion of the 1-byte or 1-word transfer in progress, then releases the bus, which passes to the
CPU.
The channel on which transfer was interrupted can be restarted by setting the DTME bit to 1
again. Figure 7.35 shows the procedure for continuing transfer when it has been interrupted by an
NMI interrupt on a channel designated for burst mode transfer.
Rev.6.00 Mar. 18, 2009 Page 284 of 980
REJ09B0050-0600
Figure 7.35 Example of Procedure for Continuing Transfer on Channel Interrupted by
transfer on interrupted
DMAC and NMI Interrupts
Transfer continues
Set DTME bit to 1
Resumption of
DTME = 0
DTE = 1
channel
Yes
No
[1]
[2]
NMI Interrupt
Transfer ends
[1]
[2]
Check that DTE = 1 and
DTME = 0 in DMABCRL.
Write 1 to the DTME bit.