Z86D7308VSC1987 Zilog, Z86D7308VSC1987 Datasheet - Page 32

• Manufacturer Part Number: Z86D7308VSC1987
• Description: IC 32K OTP 3 VOLT 44-PLCC
• Manufacturer: Zilog
• Series: Z8® IRr

Specifications of Z86D7308VSC1987

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 8MHz
• Peripherals: Brown-out Detect/Reset, LVD, POR, WDT
• Number Of I /o: 31
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: OTP
• Ram Size: 236 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 3.6 V
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 44-LCC (J-Lead)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Connectivity: -

Functional Description
PS019401-1102
RESET (Input, Active Low)
Program Memory
RAM
Note:
Comparator Inputs
In analog mode, P31 and P32 have a comparator front end. The comparator refer-
ence is supplied to P33 and Pref1. In this mode, the P33 internal data latch and its
corresponding IRQ1 are diverted to the SMR sources (excluding P31, P32, and
P33) as indicated in Figure 13 on page 23. In digital mode, P33 is used as D3 of
the Port 3 input register, which then generates IRQ1.
Comparator Outputs
These channels can be programmed to be output on P34 and P37 through the
PCON register.
Reset initializes the MCU and is accomplished either through Power-On, Watch-
Dog Timer, Stop-Mode Recovery, Low-Voltage detection, or external reset. During
Power-On Reset and Watch-Dog Timer Reset, the internally generated reset
drives the reset pin Low for the POR time. Any devices driving the external reset
line need to be open-drain in order to avoid damage from a possible conflict dur-
ing reset conditions. Pull-up is provided internally.
The Z86D73 incorporates special functions to enhance the Z8’s functionality in
consumer and battery-operated applications.
The Z86D73 addresses 32 KB of OTP memory. The first 12 bytes are reserved for
interrupt vectors. These locations contain the five 16-bit vectors that correspond to
the five available interrupts.
The Z86D73 device features 256 bytes of RAM. See Figure 15.
Comparators are powered down by entering Stop Mode. For
P31–P33 to be used in a Stop-Mode Recovery source, these
inputs must be placed into digital mode.
P
R
E
L
I
M
I
N
A
40/44/48-Pin Low-Voltage IR OTP
R
Y
Z86D73
26