Z8F012ASJ020EG Zilog, Z8F012ASJ020EG Datasheet - Page 22

• Manufacturer Part Number: Z8F012ASJ020EG
• Description: IC ENCORE XP MCU FLASH 1K 28SOIC
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F012ASJ020EG

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: IrDA, UART/USART
• Peripherals: Brown-out Detect/Reset, LED, LVD, POR, PWM, Temp Sensor, WDT
• Number Of I /o: 23
• Program Memory Size: 1KB (1K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 16 x 8
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 28-SOIC (7.5mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4042; Z8F012ASJ020EG

Signal Descriptions
Table 2. Signal Descriptions
PS022825-0908
Signal Mnemonic
General-Purpose I/O Ports A–D
PA[7:0]
PB[7:0]
PC[7:0]
PD[0]
Note: PB6 and PB7 are only available in 28-pin packages without ADC. In 28-pin packages with ADC, they are
UART Controllers
TXD0
RXD0
CTS0
DE
Timers
T0OUT/T1OUT
T0OUT/T1OUT
T0IN/T1IN
Comparator
CINP/CINN
COUT
replaced by AV
Table 2
page 9 to determine the signals available for the specific package styles.
DD
and AV
I/O
I/O
I/O
I/O
I/O
describes the Z8 Encore! XP F082A Series signals. See
O
O
O
O
O
I
I
I
I
SS
Description
Port A. These pins are used for general-purpose I/O.
Port B. These pins are used for general-purpose I/O. PB6 and PB7 are
available only in those devices without an ADC.
Port C. These pins are used for general-purpose I/O.
Port D. This pin is used for general-purpose output only.
Transmit Data. This signal is the transmit output from the UART and IrDA.
Receive Data. This signal is the receive input for the UART and IrDA.
Clear To Send. This signal is the flow control input for the UART.
Driver Enable. This signal allows automatic control of external RS-485
drivers. This signal is approximately the inverse of the TXE (Transmit
Empty) bit in the UART Status 0 register. The DE signal may be used to
ensure the external RS-485 driver is enabled when data is transmitted by
the UART.
Timer Output 0–1. These signals are outputs from the timers.
Timer Complement Output 0–1. These signals are output from the timers
in PWM Dual Output mode.
Timer Input 0–1. These signals are used as the capture, gating and
counter inputs.
Comparator Inputs. These signals are the positive and negative inputs to
the comparator.
Comparator Output.
.
Z8 Encore! XP
Pin Configurations
Product Specification
®
F082A Series
Pin Description
on
11