HD64F2134FA20 Renesas Electronics America, HD64F2134FA20 Datasheet - Page 649

• Manufacturer Part Number: HD64F2134FA20
• Description: IC H8S MCU FLASH 128K 80QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of HD64F2134FA20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: IrDA, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 58
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 80-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Bit 3—Flash Memory Control Register Enable (FLSHE): Setting the FLSHE bit to 1 enables
read/write access to the flash memory control registers. If FLSHE is cleared to 0, the flash
memory control registers are deselected. In this case, the flash memory control register contents
are retained.
Bit 2—Reserved: Do not write 1 to this bit.
Bits 1 and 0—Internal Clock Select 1 and 0 (ICKS1, ICKS0): These bits control 8-bit timer
operation. See section 12, 8-Bit Timers, for details.
21.6
When pins are set to on-board programming mode, program/erase/verify operations can be
performed on the on-chip flash memory. There are two on-board programming modes: boot mode
and user program mode. The pin settings for transition to each of these modes are shown in table
21.6. For a diagram of the transitions to the various flash memory modes, see figure 21.3.
Only advanced mode setting is possible for boot mode.
In the case of user program mode, established in advanced mode or normal mode, depending on
the setting of the MD0 pin. In normal mode, only programming of a 56-kbyte area of flash
memory is possible.
Table 21.6 Setting On-Board Programming Modes
Note:
Bit 3
FLSHE
0
1
Mode Name
Boot mode
User program mode
Section 21 ROM
* Can be used as I/O ports after boot mode is initiated.
On-Board Programming Modes
Description
Flash memory control registers deselected
Flash memory control registers selected
(Mask ROM Version, H8S/2138 F-ZTAT, H8S/2134 F-ZTAT, and H8S/2132 F-ZTAT)
Mode
CPU Operating Mode
Normal mode
Advanced mode
Advanced mode
0
MD1
1
Rev. 4.00 Jun 06, 2006 page 593 of 1004
MD0
0
0
1
P92
1 *
—
—
REJ09B0301-0400
P91
1 *
—
—
(Initial value)
P90
1 *
—
—